|
[China]
Trade Verify
Address: No.265 of zhongshan road ,shijiazhuang city ,heibei province ,china 050000
Contact name:zhijing.gao
Huihao Hardware Mesh Product Limited |
|
Verified Suppliers
|
|
|
Material: Low carbon steel, Aluminum, Stainless steel
Plating: Cooper plating for low carbon steel
Self-locking washer: Available in all kinds of shapes, sizes and materials
Size:
Pin Diameter: 10GA( 3.4mm), 3mm, 12GA( 2.7mm) 14GA(2.0mm)
Pin Length
3/4" 1" 1-1/2" 2" 2-1/2" 3" 3-1/2" 4" 4-1/2" 5" 5-1/2" 6" 6-1/2" 7"
etc
Application:
1: weld pins in place
2: install insulation on pins
3: press washers on pins
4: bend over the pin or clip off the pins
Package:
1. 100 pcs ,200 pcs ,300pcs ,500 pcs in one plastic bag (according the pin length ),
2. 10 bags in one carton box,
3. then in one pallet
4. the package can be can according your request 
MATERIAL | LOW CARBON STEEL | STAINLESS STEEL | ALUMINUM | |
|---|---|---|---|---|
| C - 0.23% max | P - 0.04% max. | AISI grade - 302/304/305 std. Other grades available upon request. | Alloy - 1100-H14 standard. Other alloys available upon request. | |
| Mn - 0.90% max. | S - 0.05% max | |||
MECHANICAL PROPERTIES | Tensile - 60,000 psi (min) | Values for various grades available upon request. | Values for various alloys available upon request. | |
| Yield - 50,000 psi (min.) | ||||
| Elongation - 20% (in two inches) | ||||
PLATING | Copper coating is standard on pins. Copper and other platings available upon customer request. | Does not apply to stainless. | ||
ANNEALING | Pins are annealed where required | Does not apply | ||
1) Length of this style pin should exceed the thickness of the insulation, in order to securely
attach the self-locking washer.
2) Nail point is standard - available with "blunt end" as special order.
3) Capacitor Discharge weld pins simplify the permanent attachment of insulation to just about
any kind of construction metal surface.
4) They can be applied quickly and easily using standard CD or Arc
stud welding equipment.
5) Weld pins are available in different styles to cover a wide
variety of applications.
6) Some factors to consider regarding the pin style needed for your job would be the base
metal type size and surface condition, and also the welding equipment to be used.
The standard, portable CD system consists of:
1) The Controller or (Power Unit) which is plugged into the one-hundred-and-ten-volt outlet.
2) The CD Gun with cables is used to command the power unit and deliver weld current,
with the Gun also serving as the Pin holder to properly place the pin during welding.
3) Then, on the other side of “the circuit” a ground cable and clamping connection is attached
to the work-surface to complete our Capacitor Discharge connections.
4) And finally, special accessories are used to hold the Pin in the Gun.
