|
[China]
Trade Verify
Address: No.265 of zhongshan road ,shijiazhuang city ,heibei province ,china 050000
Contact name:zhijing.gao
Huihao Hardware Mesh Product Limited |
|
Verified Suppliers
|
|
|
Capacitor Discharge Threaded Stud Welder , CD Stud Welding Machine
for Weld Stud
Product Description:
Threaded Stud Welder , CD Stud Welding Machine Technical
features :
The utility model has the advantages of novel design, compact
structure, reliable use, stepless regulation of charging
voltage,large regulating range and convenient adjustment of various
parameters.
This is the use of capacitor discharge welding machine, fast to
insulation nails firmly welded on the work piece.It has
to improve production efficiency Rate, reduce production,
reduce the production cost (materials, labor, electricity),
welding intensity is high.The characteristics of deformation
and welding position can be convenient, easy to operate, was quick
tolearn.
| Model | CDM8 | CDM8 |
| Variant | Contact | Lift Gap |
| Nominal Capacitance | 66,000mf | 66,000mf |
| Weld Range Mild Steel | 2-8mm | 2-8mm |
| Weld Range Stainless Steel | 2-8mm | 2-8mm |
| Weld Range Al.Alloy | 2-6mm | 2-6mm |
| Weld Range Zintec | 2-6mm | 2-6mm |
| Weight – controller only | 16kg | 16kg |
TECHNICAL SPECIFICATION - CONTROLLER
| Mains input | 115 and 230V AC, 50-60Hz, 1 Phase |
| Input power | 1.8 KVA |
| Input fuse rating | 16A at 115V, 10A at 230V |
| Output voltage | 35-200V |
| Output power source | Electrolytic Capacitors |
| Weld rate | 10-50 studs per minute |
| Weld range | 2-10mm |
| Enclosure | Class IP31 protection |
Threaded Stud Welder , CD Stud Welding Machine is widely used in shipbuilding, have higher economic
benefit.Mainly used for welding of carbon steel,stainless steel
bar, without flux and protection measures, with conform to the
requirements of the strong Degree and micro structure.The
combination of several kinds of main material are shown in table
welding preparation
(1) insert the earth wire electrode holder, control line, quick
connectors welding machine control panel connection port;
(2) insert the power input line welding power input port, and open
the power control switch;
Remark: this equipment is a low frequency, do not and argon arc
welding machine and other high frequency
equipment sharing power Mouth, mouth, and make using the equipment
with more distance.
(3) check whether the indicator light is open;
(4) the voltage regulation knob to turn check whether can normal
working voltage charging and discharging;
(5) the adjustment of the charging voltage
Before plug-in power charging voltage adjustment knob shall be
transferred to the smaller values, and then switched on.Slowly
clockwise rotation Adjust knob, and watch the charging voltage
meter, adjust until the required working voltage, after
working voltage is set,After each welding welding machine can
automatically recharge to the set value.
Insulation pin diameter charging voltage(v) remakes
M3 120-130 According to actual demand intensity parameter
adjustment
M4 135-155 According to actual demand intensity parameter
adjustment
