Lab PVC EVA Rubber Mix Mill Plastic Material Two Roll Open Mixing Mill Equipment

Lab PVC EVA Rubber Mix Mill Plastic Material Two Roll Open Mixing Mill Equipment

Application:

It is widely used in rubbers and plastics industry for polymer mixing, such as PVC, color master batch. It consists of roll, bearing, gap adjusting device, electric control system, safety device, etc.

ZL-3018 Two roll mill.pdf

Introduction:

Two Roll mill : The two drums rotate, and the prepared samples are poured along the grooves above the two drums. The baffles on both sides can also be slightly adjusted as needed. The two rollers are rotated, and the prepared samples are poured along the grooves above the two rollers, and the baffles on both sides can also be slightly adjusted as required. During the operation of the silicone mill, if there is an emergency, the leg and elbow should immediately hit the safety door panel, and the built-in control switch can make the forward rotating double drum reverse immediately to relieve this dangerous state.

Technical parameters:

Advantage Service:

1. We have R&D, designing department which can not only provide technological machines but also can satisfy special customized needs of our clients.

2. Over 50 years’ manufacturing experience, advanced machine and sophisticated handcraft.

3. There are TWO laboratories in our factory: Environmental laboratory and Physical laboratory.

4. Our factory have adequate stock monthly, which can meet customers’ urgent needs.

5. Annual sales over 1,000,000USD; 30,000㎡manufacturing base, equipped with 120 technicians, we are capable to take large budget project.

Technical Support:

1. SUS Stainless plate is cut by advanced leaser machine which can ensure accuracy; All machine appearance is anti-rust electrostatic painting;

2. Imported electronic components: ABB/Siemens/Panasonic/Saginomiya/Danfoss/Emkarate/Omron and imported compressor:BOEK/TECUMSEH, which can keep the machine’s service life over 10 years.