0.35mm Thickness Galvanized Diamond Hole Brickwork Reinforcement Mesh

0.35mm Thickness Galvanized Brick Reinforcement Mesh Diamond Hole

Brickwork Reinforcement Mesh are produced for brick and block work reinforcement.We can produce the length from 10m-100m.Their primary uasge is to prevent cracking, embedded in the normal thickness of a brickwork joint, brick reinforcement meshes reduce the detrimental effects of vibration and changes of temperature. Brick reinforcement meshes increase resistance to tensional stress.

Material:

Galvanized plate

Specification:

Hole Type: Diamond

Hole Size: 16*28mm Llike the photo

width: 10cm, 15cm, 20cm,30cm

Length: 10m-100m

How to Install  Brickwork Reinforcement Mesh:

The coil mesh is laid in strips between brick or block courses leaving approximately 25mm clearance from the faces of the work. Where coil mesh joins are required, ensure they overlap by at least 75mm.

The reinforcement is then simply embedded in the mortar for the next course.

In most instances, application every third course, for the full length of the wall, will be sufficient.

To reinforce brickwork at an opening, e.g. window or door, mesh should be installed to overlap part of the opening, and part of the solid wall.

Thinking of the width of the opening, lay the mesh approximately a quarter of the way across the opening. The mesh should lie the same distance again, across the solid wall.

Above windows or doors, install Catnic mesh for 2-3 courses, starting from the course above the lintel .