|
Trade Verify
Address: Room 1306, Block C, Blue Ocean building, Qianshan Road, Hefei, China.
Contact name:Linda Qiang
Briture Co., Ltd. |
|
Verified Suppliers
|
|
|
Concrete Reinforcing Polypropylene Macro Synthetic Reinforced Fiber For Concrete
Synthetic Macro fiber
Product Description
Briture Synthetic Macrofiber is made of Polypropylene. Polypropylene macro fiber (PP macrofiber)for concrete is one
of pp fiber used for reinforcing concrete products and mainly used
for structural fibers.
Provide good impact,fatigue,shrinkage control and ductility in
all grade concretes.Cost saving,Is easier to use,to disperse and
safe to handle.Can be used in highly corrosive circumstance.The
surface has been embossed,which greatly improves the cohesive force
between fibres and concrete,and also boosts shrinkage resistance
and crack resistance.The toughness of macro synthetic fibre is less
stronger than steel fibre.But test has shown slabs on grade and
pre-cast concrete predominately require a dosage rate of between
25kg-40kg of steel fibres per cubic meter, in comparison,using
between 3kg-10kg of macro synthetic fibre per cubic meter of
concrete. Synthetic fibres achieve greater strength and ductility
in the matrix.Estimating Data
These fibers are wrapped in bundles of water-soluble film and
packed in cartons. When used, just put the whole boxes of the
fibers into concrete.
The cartons and film are dissolved in water and the fibers are
evenly dispersed in the concrete mixture.
Available Length: 48mm, 54mm, 64mm...
Features
1. All grades of concrete to provide good anti - fatigue, anti -
shrinkage, anti - seismic and good toughness.
2. Simple operation, not easy to group, safety, reasonable price,
cost savings..
3. Improve the supporting performance and bonding performance of concrete to produce effective secondary strengthening effect; Provide high residual strength of concrete and improve the durability of concrete;
4. Coarse fiber is most suitable for shotcrete, which can reduce rebound, reduce cost, form a thicker shotcrete layer, significantly improve bending strength, easy pumping and will not damage mechanical equipment.
Proposed Dosage
The dosage rate is dependent on the actual application however the
minimum dosage range is 3kg/ m3-6kg / m3
Typical Application
Shotcrete, concrete engineering, such as foundations, roads,
Bridges, DAMS, especially in the deformation and toughness of the
higher
requirements of the project.
Specification
| Minimum Tensile Strength | ≥550MPa |
| Modulus | ≥9000Mpa |
| Fiber Dimension | L: 48mm/54mm/64mm;T: 0.55-0.60mm; W: 1.30-1.40mm |
| Melt Point | 170℃ |
| Density | 0.91g/cm3 |
| Melt flow | 3.5 |
| acid&alkali resistance | Excellent |
| Moisture Content | ≤0% |
| Appearance | Embossed |
Packing
5kg/ box, 1200-1300kgs/pallet, 12800kgs/1X20`FCL, 25600kgs/1X40`FCL
Packing image:
