Xi 'an West Control Internet Of Things Technology Co., Ltd. |
Verified Suppliers
|
|
Cement Corrosive Liquid Water Measuring IP65 Insertion Electromagnetic Flow Meter
Plug-In Insertion Type Electromagnetic Insertion Flow Meter
NYLL-CR plug-in electromagnetic flow meter is a new flow meter developed on the basis of pipeline electromagnetic flow meter. In the pipeline flow detection, the installation is simple, can constantly flow, the site can take the pressure open hole, with absolute installation advantages and price advantages. It retains the advantages of pipeline electromagnetic flowmeter, aiming at the difficult installation and large cost on the pipeline, according to Nikura magnetic (NIKURADS) Principle, the average flow rate of the fluid is measured to obtain the volume flow of the fluid.
It is suitable for liquid flow detection with water, sewage, acid,
strong alkali conductivity above 20cm. The change of conductivity
does not affect the change of performance, and strongly adapt to
the complex changes of fluid, especially for the flow measurement
of water supply and drainage pipes. Especially after the use of the pressure opening hole and pressure
installation technology, the plug-in electromagnetic flow meter can
be installed without stopping water, or on the cast iron pipe and
cement pipe. It is only related to the insertion depth, so it is widely
versatile and has strong interchangeability.One type can be
applicable to the fluid measurement requirements for various
specifications of piping.The range automatic switch function.When
the flow meter changes in the flow range, the flow range can be
automatically switched to ensure the accurate measurement within
the full flow range. The successful development of the plug-in electromagnetic flowmeter
provides a new method for fluid flow detection.
The plug-in type, like the pipeline flange electromagnetic
flowmeter, works according to Faraday's law of electromagnetic
induction.
Plug-In Insertion Type Electromagnetic Insertion Flow Meter Technical Parameters
Caliber | 300~ 3000 mm |
Speed range of the flow rate | 0 . 1~10 m/ s |
Precision | 0 . 1~0 . 5 m/s: ±2 . 0 % FS 0 . 5~10 m/ s: ±1 . 5 % FS 0 . 1~10 m/ s: ±2 . 5 % FS |
Electroconductibility | > 50μs/ cm |
Straight pipe section | anterior 5 DN ; posterior 3 DN |
Medium temperature | - 20℃ ~+ 130℃ |
Ambient temperature | - 20℃ ~+ 60℃ |
Withstand voltage | 1 . 6 Mpa |
Levels of protection | IP 65, IP 68 |
Electrode material | 316 L stainless steel |
Output signal | 4 - 20 m A;RS 485;HART protocol;MODBUS protocol |
Sensor material | stainless steel |
Operational principle | 220 VAC, tolerance15 % 24 VDC, ripple wave≤5 % |
Capacity factor | 6 . 5 W |
Pressure resistance level | ≤1 . 6 Mpa |