|
[China]
Trade Verify
Address: Room 1807,Block A,Qunxing-Square,Huaqiang North Road,Shenzhen,Guangdong,China
Contact name:Dream Chan
Shenzhen Yujies Technology Co., Ltd. |
|
Verified Suppliers
|
|
|
High Accuracy Ultrasonic Sensor Distance Measurement With ABS Housing
Highlights
| Technical data | |
| General Specifications | |
| Sensing distance | 100…1000mm |
| Adjustment range | 200…4000mm |
| Unusable area | 0…80mm |
| Standard target plate | 100mm×100mm |
| Transducer frequency | |
| Response delay | About 195ms |
| Indicators/Operating means | |
| LED blue | Power on |
| LED yellow | Flashing:program function object detected |
| LED red | permanently red: Error Red,flashing:object not detected |
| Electrical specifications | |
| Operating voltage UB | 10 … 30 V DC 4.2 … 5.5 V DC |
| No-load supply current | ≤20mA |
| Electrical Interface | PVC cable |
Dimensions | 36 X 56 X 26 |
| Output | |
| Output type | 1 switching PNP output 1 analog output (current or voltage) 1 digital output (RS232/485 or UART TTL) |
| Rated operational current | 200mA,short-circuit/overload protected |
| Default setting | 80mm----0V/4mA, 2000mm----10V/20mA |
| Voltage drop | ≤ 3V |
| Repeat accuracy | ≤ 1% |
| Switching frequency f | ≤ 4HZ |
| Range hysteresis H | 1% of the set operating distance |
| Temperature influence | ± 1.5% of full-scale value |
| Ambient conditions | |
| Ambient temperature | -40°C to 70°C |
| Storage temperature | -40…85℃(233...358K) |
| Mechanical specifications | |
| Protection grade | IP68 |
| Connection | V1 connector(M12×1),4-pin |
| Material Housing | ABS |
| Transducer | epoxy resin/hollow glass sphere mixture; foam polyurethane,cover PBT |
configuration | Command(digital output) |
Electrical Interface | M12-4PIN |
| Standard conformity | EN 60947-5-2:2007 IEC 60947-5-2:2007 |
Installation conditions
If the sensor is installed at the environment temperature fall below 0℃,It should do well on the protective measures. In case of direct mounting of the sensor in a through hole using the steel nuts, it has to be fixed at the middle of the housing thread.
V1 Connector
