KHB - G1/4 G3/8 Floating Ball Valve High Pressure With 500 Bar

KHB - G1/4 G3/8 Floating Ball Valve High Pressure With 500 Bar

Ordering Code: KHB-G1/8, KHB-G1/4, KHB-G3/8

Order code

Description

The HYDAC family of dependable high pressure ball valves provides full, unrestricted flow and positive shut-off of fluids and gases under extreme service conditions. Models are available to accommodate system pressures up to 7,250 PSI. Since a variety of materials are available, HYDAC valves can be used with various fluids and gases including petroleum based oils and some water glycols.

Specifications

1. 1/4” - 2” Full Port Design
2. NPT or SAE O-Ring connections
3.  Polyacetal Ball Seals (standard)
4. FPM (Fluoroelastomer) O-Rings (standard)
5. Carbon Steel Housing
6. Block Housing - Sizes 06 - 25
7. Forged Housing - Sizes 32 - 50
8. Operating Pressure to 7250 psi Depending on Valve Size and Seal Materials Selected
9. Temp Range: 14°F to 176°F with Standard materials (1114) up to max. pressure rating. Extended Temperature range -40°F to 392°F on request with special materials and reduced pressure rating (see page 20).

Valve Design
The design of HYDAC ball valves is based on the “floating ball” principle which allows the ball to turn freely between the ball seals. A positive seal is attained by fluid pressure acting on the upstream surface of the ball and producing a constant uniform contact between the downstream ball seal and the ball. The ball is operated by a sealed spindle with a projecting square end to which the control handle or optional actuator is attached. Ball valves are intended to be used as on/off flow control devices and are not to be used to throttle fluid flow. The valves should always be either fully open or closed.

Product Features

1. Full passage for unrestricted flow of medium
2. Floating ball provides positive seal
3. Direction of flow indicated by milled slot in control spindle
4. Valve positioning controlled by a stop pin and limit washer
5. Fluoroelastomer O-rings (standard)
6. Phosphate coated carbon steel valve body (standard)

Available Options
HYDAC can furnish ball valves with special options including:
1. Locking devices
2. Stainless steel valve bodies
3. Pneumatic or electrical actuators
4. Limit switch
5. Off-set or straight control handles
6. Custom solutions - Contact HYDAC

Product show:

Quality Standards :

The company for the products are brand new original products, no second-hand and refurbished products, or leave a compensable ten and return the full amount , but the buyer due to our purchase of model error is not responsible for returns, another of the company's sales of products enjoy one year from the date of shipment quality assurance , according to the original quality standards , during warranty with product problems , need confirmation testing by the manufacturer , the supplier to be solved , the demand side due to storage , use, poor maintenance caused by lower-quality product , and not raise objections

Warranty:

All item Comes with Basic 3 Month Sellers Warranty, if item defective in 3 Month, We will offer replacement without extra Charger(including shipping fee)After we Receive the Defective item.
If item Defective after 3 Month, Buyers can still send it back, We will contact suppliers or Manufactory for Warranty. Buyers Might Need to pay the Shipping fee For resend the replaced item.

Competitive Advantage: