Hot / Cold Cycling Water Flow Testing Equipment For Shower Hose Pulse 25s/Pcs

T06 PLC Control Pneumatic Clamp ,Servo Gate Valve Torque Testing Machinee

Equipment function:

1. Pneumatic clamp fast install products,lifting device can put down and rise products from sink.

2. Servo motor drive valve open and close,Closed torque can be set up.

3. Testing time can be set up,change time setting ,need enter the password

4. Test process can be run automatically ,clamp rise automatic after testing time,and close inlet air.
5. Clamping pressure and test pressure can be adjusted

6. Can press the emergency stop button to stop testing ahead of schedule, and the rise the clamp

Equipment structure:

1. Stainless steel frame,four wheel equiped at the bottom

2. The main material of clamp is s/s and brass material,cylinder achieve clamping and lifting

3. Servo motor open and close valve,torque can be set up after valve close.

4. Control system: PLC, touch screen, electrical system

5. Machine roof have lighting and a sink equiped on the right

Function:

1, flow and pressure can be adjusted;
2, the water temperature can be set, at room temperature to 90 C range can be arbitrarily set;
3, can be carried out 0.01MPa low voltage flow test;
4, touch screen display water temperature, flow, pressure value
5, generation time flow curve;
6, print test results.

Operation instructions

1 start the test equipment, set the time of holding pressure, test the torque value;

2 to adjust the clamping pressure and test pressure;

3 valve placed in the fixture, press the start test button automatically following actions: valve clamp, clamp sank into the water, into the air pressure and the rotation of the motor to close the valve, test time after the walk off the intake, rising clamp, the clamp is released;

4 if you need to abort the test ahead of time, press the emergency stop button;

5 adjust the intake throttle valve can adjust the clamping, lifting speed

Equipment description

1 rated voltage 220V, working voltage 24V;

2 pressure test product specifications: 3/8 "- 2", for the valve length is 30-100mm;

3 pressure test time: 1 ~ 1000 seconds with a password can be arbitrarily adjusted;

4 pressure test station: station, each station can operate independently, independent control button, time of showing independence, independence of the ups and downs of water, device independent jobs.

5 torque setting range 1-10Nm

Applicable products: faucet, shower hand, hose, angle valve, flow rate is not greater than 35L/min, the test pressure is less than 0.6MPa