|
[China]
Trade Verify
Address: 1602, No.1 Plaza, No.2 Lujiang Road, Siming District, Xiamen Fujian China
Contact name:kerry
Sumset International Trading Co.,Ltd |
|
Verified Suppliers
|
|
|
IC693MDL930 OUTPUT RELAY 4A 8PT ISOLATED GE Fanuc PLC
Product Details:
The GE Fanuc IC693MDL930 is a 4 Amp Isolated Relay Output module.
Designed for the Series 90-30 Programmable Logic Controller, this module provides 8 normally-open relay circuits.
These enable the user to control output loads. Each circuit has a 4-amp output switching capacity.
Each output point on the module is isolated from the other points and each point has a separate common power output terminal.
Rated Voltage
24 volts DC, 120/240 VAC (nominal - see the following table for exceptions)
Operating Voltage
5 to 30 volts DC
5 to 250 VAC, 50/60 Hz
Outputs per Module
Eight isolated outputs
Field to Backplane and to Frame Ground
250 VAC continuous;
1500 VAC for 1 minute
Point to Point
250 VAC continuous; 1500 VAC for 1 minute
Maximum Load
4 Amps resistive maximum per output
2 Amps pilot duty per output
20 Amps maximum per module for UL installations
Maximum Load depends on the ambient temperature as shown below
Minimum Load
10mA
Maximum Inrush
5 Amps
On Response Time
15ms maximum1
Off Response Time
15ms maximum1
Power Consumption
6mA (all outputs on) from 5 volt bus on backplane
70mA (all outputs on) from relay 24V bus on backplane
When this module is used with DC power supply IC695PSD040 or
PSD140, special precautions should be taken because dropouts in the
source voltage will be seen by this module and may cause relay
dropouts.
