Philip Wearable MX40 Patient Monitor Battery Cover Casing DLP-001-04

Philip MX40 Patient Monitor Battery Cover Casing DLP-001-04

Philip MX40 Patient Monitor Battery Cover Casing DLP-001-04 Brief Introduction 

Philip MX40 Patient Monitor Battery Cover Casing DLP-001-04  is located on the back of the MX40, accessible from the bottom by opening

the battery compartment door. It holds three AA 1.5V alkaline batteries or philip rechargeable Li-ion batteries.The battery door is to protect the

battery from dropping,dusty ,water .And it's made of durable plastic .It's easy to use .

Philip MX40 Patient Monitor Battery Cover Casing DLP-001-04 Specification 

Inserting Battery

1.Open the battery compartment by lifting up on both bottom sides of the compartment door.

2.Remove the AA battery tray if present.

3.Insert the battery pack so that the raised tab is aligned with the cutout in the base of the battery compartment.

4.Close the battery compartment door.

Some warnings for Philip MX40 Patient Monitor 

The MX40 works exclusively via a wireless network connection. Therefore, it should not be used for primary monitoring in applications where

transient ECG loss is unacceptable in the reporting center. Sends ECG and optionally pulse oximetry data to the information center, where the

information center displays real-time patient data, provides alerts, data storage and verification applications. ECG waveform data, alarms and

optionally SpO2 can always be displayed on the MX40, regardless of the connection to the information center. Due to the inherent nature of radio

frequency and the many variables that affect live communication, a wireless patient monitoring system will never be as reliable as a patient

monitoring system that transmits the signal over a cable. This factor should be considered when deciding to monitor patients using wireless

technologies. If occasional failure of ECG monitoring in the information center is clinically unacceptable for some patients, alternatives should be

sought. Because the IntelliVue MX40 does not provide a wired network connection, we recommend using an IntelliVue patient monitor with a

wired connection to the information center for these patients.

If you're interested in Philip MX40 Patient Monitor Battery Cover Casing DLP-001-04 ,feel free to contact us .Thank you .