Lime Green Single Mode Fiber Optic Patch Cables 50/125 OM5 SC Duplex Simplex

Application prospect of OM5 fiber jumper in data center in future:
- OM5 fiber optic jumper to very large data center gives a stronger vitality, it breaks through the traditional multimode fiber parallel transmission technology and adopted by the bottleneck of transmission rate is low and can not only with less multimode fiber some support more high-speed network transmission, and because it USES a low cost, short wavelength light module cost and power consumption is far lower than that of single mode fiber with long wave laser light source. Therefore, in the future 100G/400G/1T super-large data center will have a broad application prospect.
- Taking the future generation of 400G Ethernet optical fiber wiring as an example, 16 core fibers are needed for transmitting signals and 16 core fibers for receiving signals. A total of 32 core fiber multi-mode fibers are needed, which means the data center needs to deploy the wiring system with 32 core MPO/MTP interfaces. Therefore, the high wiring cost will put off the data center designers.
- If the OM5 fiber jumper wire and the light of short wavelength division multiplexing module, only need a total of eight core multimode fiber, including four core optical fiber is used to send signals, the other 4 core optical fiber is used for receiving signals, and each optical fiber transmission four wavelength, the transmission rate of each wavelength 25 GBPS, therefore, fiber jumper OM5 100 GBPS per core optical fiber can transmit data. By adopting the technology of short wavelength division multiplexing and parallel transmission, the wiring cost of the data center will be greatly reduced, and it is believed that the OM5 fiber jumper will be widely used in the near future.

 

Product Photo:

 

 

5 reasons to use OM5 fiber:
- The OM5 fiber specification has been issued by the communications industry association as tia-492aaae, and is in the final voting stage at IEC as IEC 60793-2-10 version 6.
- The OM5 and tia-492aaae specifications will be recognized in the upcoming ISO/IEC 11801 version 3 and American national standards association wiring standards ANSI/ tia-568.3-d.
- OM5 fiber is at least as good as OM4 in supporting all traditional applications, and it is fully compatible and interoperable with OM3 and OM4 fiber.
- The OM5 is designed to support at least four low-cost wavelengths in the 850-950 nanometer range, enabling optimized support for emerging short-wavelength division multiplexing (SDWM) applications that reduce the number of parallel fibers by at least four times, can use just two fibers (instead of eight) to continuously transmit 40Gb/s and 100Gb/s, reduce the number of fibers, and achieve higher speeds.
- The OM5 has been sold worldwide, and pre-end-to-end fiber optic jumper provided by Sun Telecom pujin has been installed in a variety of network environments, including campuses, buildings and data centers.
Compared with traditional OM3 and OM4 fiber, OM5 has significant advantages in supporting SWDM applications. In the future, SWDM technology may also be used to achieve Ethernet speeds of 200, 400 and 800Gb/s in multimode fiber.