Active Member
|
[China]
Address: ROOM 2204, NO.98， TIANGAO ALLEY, SOUTH BUSINESS DISTRICT, YINZHOU, 315194, NINGBO, CHINA
Contact name:Roy Zhang
Ningbo Anyo Import & Export Co., Ltd. |
|
|
Through hole 50A high current bridge rectifiers KBPC5010 single-phase
Description
A diode bridge rectifier is a device for converting AC, or alternating current electricity into DC, or direct current. AC electricity goes from positive to negative constantly, whereas DC always flows in the same direction. AC electricity is more efficient to transmit and easier to convert into different voltages, so power is transmitted from the station to your house as AC. However, most appliances need DC current to run. A diode bridge rectifier is the most common type of power supply used to provide this current.
Bride rectifiers are classified into several types based on these factors: type of supply, controlling capability, bride circuit’s configurations, etc. Bridge rectifiers are mainly classified into single and three phase rectifiers. Both these types are further classified into uncontrolled, half controlled and full controlled rectifiers.
The main advantage of this bridge circuit is that it does not require a special centre tapped transformer, thereby reducing its size and cost.
Features:
• Metal case for maximum heat dissipation
• Surge overload ratings-400 Amperes
• Low forward voltage drop
Mechanical data:
• Case: Metal, electrically isolated
• Epoxy: UL 94V-0 rate flame retardant
• Terminals: Plated .25"(6.35mm) Faston lugs, solderable per
MIL-STD-202E, Method 208 guaranteed
• Polarity: As marked
• Mounting position: Any
• Weight: 30 grams
Application:
It is used in many electronic devices including laptop computers, cellular phones and PDA's. Depending on how you're viewing the electronic component
Maximum ratings and electrical characteristics:
Rating at 25℃ ambient temperature unless otherwise specified.
Resistive or inductive load,60HZ.
For capacitive load, derate current by 20%
| Characteristics | Symbol | KBPC5010 | Unit |
| Maximum recurrent peak reverse voltage | VRRM | 1000 | V |
| Maximum RMS bridge input voltage | VRMS | 700 | V |
| Maximum DC blocking voltage | VDC | 1000 | V |
| Maximum average forward rectified output current. @Ta=55°C | I(AV) | 50.0 | A |
| Peak forward surage current 8.3ms single half sine-wave super impossed on rated load(JEDEC method) | IFSM | 400 | A |
| Maximum instantaneous forward voltage drop per bridge element at 25A | VF | 1.1 | V |
Maximum DC reverse current @Ta=25°C at rated DC blocking voltage per element @Ta=100°C | IR | 10.0 500 | uA |
| Rating for fusing(t<8.3ms) | I2t | 664 | A2sec |
| Typical junction capacitance | Cj | 300 | pF |
| Typical thermal resistance | RθJA | 2.2 | ℃/W |
| Operating junction temperature range | TJ | -55~150 | ℃ |
| Storage temperature range | TSTG | -55~150 | ℃ |
NOTES :
1. Measured at 1 MHZ and applied reverse voltage of 4.0 volts
2. Thermal Resistance from Junction to Case per leg.
Dimension:(mm)
