61 Watts Mini Water Cooler Dispenser 85-95 Degrees Centigrade Small
Cute Appearance with good sales on Amazon. To get more know
products information, please visit the below link on Amazon from
one of our UK customers, thanks!
https://www.amazon.co.uk/dp/B078XBL9HJ
https://www.amazon.co.uk/dp/B01NAP7OU5
Products component checklist :
Technical and Replacement filters
| System Specification |
Electrical Requirements | 220 - 240V , 50/60 Hz |
Input cooling | 61 Watts |
Filter replacement model | |
Filter cartridge life | 150 litres or 2 months |
Filter cartridge flow rate | 100-400ml/minute |
Filter reduction capabilities | Chlorine, lead, copper, etc |
Products weight | 3.2 KGS |
Total water tank capacity | 8.5L |
Filtered water tank capacity | 5L |
Unfiltered water tank capacity | 3.5L |
Sterilising and Cleaning Instructions
It is important to follow the sterilising and cleaning process
below before using and as part of your regular maintenance
routine:
- Combine two tablespoons of baking soda with 2 litres of
lukewarm water in a separate container
- Remove the unfiltered water chamber from the cooler
- Pour the bicarbonate solution into the water chamber
- Press the water dispenser until water pours from the tap
- Cycle the bicarbonate solution through the tap and empty into the
top water chamber, Repeat this procedure several times
- Turn on the power and leave for at least 4 hours
- Drain all the bicarbonate solution until empty
- Remove the drain plug from underneath the unit to drain any water
or solution in the cooling tank. This is vital to ensure the solution is expelled from the cooler
- While the drain plug is open, rinse the unit with 2 litres of clean
water to remove any bicarbonate solution
- Refit the top and water chamber
- Flush clean water through the unit and drain out via the tap, Tilt
the unit forward and backward to expell all water from unit
Products simple operation introduction :
Before first use :
- Wash and rinse out the plastic water tanks thoroughly before use
- Remove the filter from its packaging then fully cover and soak in
cold clean water for approximately 15 - 30 minutes then rinse
off under cold clean running tap water until see the clear water
then will start for using
- You may notice a fine black dust come out of the filter, this will
happen on all new filters and when water is filtered through it the
first couple of uses . This is no cause for alarm . It is just the
dust from the activated carbon inside the filter. Although it looks
unsightly , it will not harm you.
Prepare Filter
- Remove filter cartridge from plastic cover
- Do not lose the filter cartridge O-Ring
- Soak filter cartridge in water for approximately 20 minutes
- Shake filter while under water to remove dark carbon particles and
any trapped air
Insert filter and ensure it sits flat and fully seated
![](http://img.everychina.com/nimg/fe/ab/e51b5c8cd504da26f87015bb802c.jpg)
Assembly:
- Ensure Drain Plug underneath unit is secure on the unit
- Place unfiltered water chamber on to the Filtered Water Chamber
- Place Filter cartridge into the unfiltered Water Chamber. Ensure
Filter cartridge is secure
- Place top on top of water Chamber
- Turn the switch to "ON" at the back of the unit
- Empty water into the unfiltered water chamber, allow water to run
through to the Filtered water Chamber
- Once the Filtered water chamber is filled, push and hold the tap
down until water comes out of the tap
Contact details:
NINGBO GOOD WATER SOURCE ENVIRONMENTAL PROTECTION ELECTRICAL
APPLIANCE CO.,LTD
CONTACT PHONE(WHATSAPPLE): (86) 13884494576
CONTACT E-MAIL:
jackliu@miniwatercoolerdispenser.com
WECHAT: Jackliu8886
SKYPE: jackliu06316
Besides, to get more know our products information, please visit
the below link on Amazon from one of my UK customers, thanks!
https://www.amazon.co.uk/dp/B078XBL9HJ
https://www.amazon.co.uk/dp/B01NAP7OU5