ASTM A234 WPB 5D 6 Inch Steel Pipe Bend , 60 Degree Pipe Bend SCH40

ASTM A234 WPB Bend, 60 Degree, Radius 5D, 6 Inch, SCH 40, ANSI B16.49, Beveled Ends.

Bend pipe is a complete set of bending equipment for bending, divided into cold simmer and hot push two processes. No matter which kind of machine equipment and pipeline, most of them are used to bend pipe, mainly for oil, gas, infusion, engineering bridge construction and so on.

Method of use

Analysis of the main causes of the decrease in the quality of the bend pipe and the methods for attention:

• The accuracy of bending tire is also one of the factors affecting the quality of bend pipe. In the manufacture of bending tire, in addition to the specification and size requirements to control in a certain tolerance range, but also require users to use according to the bending pipe diameter to select the corresponding bending tire.
• The bending property and surface corrosion of the pipe itself may also affect the quality of the bend pipe. During site construction, the operator should also understand the material, processing performance and surface corrosion of the pipeline.
• R. available The curve of bending radius / tube diameter is used for reference when selecting the relationship between pipe diameter and wall thickness. Reflecting the influence of relative bending radius and relative wall thickness on the quality of bend pipe, according to the acceptance code of pipe processing: cold bending steel pipe, medium and low pressure 4 D, high pressure 5 D. Therefore, our bending tire design is R=4 D( special case), so the pipe bender produced by our factory mainly chooses the relative wall thickness SX, the upper part of the drawing is the coreless shaft area, the middle part of the drawing is the ordinary core shaft area, and the lower part of the drawing is the special core shaft area. Because the special core shaft design and manufacture are very difficult, the operation is not very convenient, so I generally do not supply. Special circumstances may be agreed upon separately.

Material of ASME B16.9 Bend