500X Wire Mesh Structured Packing SS316L 0.15mm wire size
Projects applying wire mesh structured packing
- Triformaldehyde was refined and separated by 500X corrugated wire
mesh packing tower. The purity of the product is more than 99.9%
and the impurity content is less than 300 ppm.
- 500 type wire mesh structured packing used in Phenol distillation
column, instead of part of Cascade Mini Ring.
- Vacuum distillation unit for dimethyl terephthalate, with 500 wire
gauze packing.
- Pentaerythritol production device, 500 type wire mesh structured
packing tower.
- Nitrotoluene isomers are separated by vacuum distillation with 700Y
corrugated wire mesh packing.
- Ethylene oxide technology upgrades, using 700Y metal mesh
corrugated packing and 250Y metal orifice corrugated packing
instead of two floating valve towers.
Hualai wire mesh structured packing products list (normal):
Type | Specific Surface | Bulk Density | Void Ratio | obliquity | ΔP | Liquid spray density | Liquid holdup | Theo. Plate | HETP | F factor | Application② |
(m2/m3) | (kg/m3) | (%) | Angle | (Pa/plate) | (m3/m2*h) | % | (piece/m) | mm | (m/s)*(kg/m3)0.5 | |
250(AX) | 250 | 45① | 98.5 | 30 | 10-40 | 0.2-12 | 2 | 2.5-3 | 100 | 2.5-3.5 | Precision distillation with few theoretical series |
500(BX) | 500 | 95① | 96.9 | 30 | 50 | 0.2-12 | 4.2 | 4-5 | 200 | 2.0-2.4 | Vacuum Distillation of Thermosensitive and Difficult Separation
Systems |
700(CY) | 700 | 130① | 95.6 | 45 | 67 | 0.2-12 | 6 | 8-10 | 333-400 | 1.5-2.0 | Isotopic mixture, isomeric mixture separation |
①The data are based on 0.12mm wire, stainless steel material.
Applicable temperature (-200—400)℃. 0.15mm and 0.17mm wire are also
available.
②Metal wire mesh corrugated packing is suitable for clean
gas-liquid system without solid particles or suspended solids or
not easy to self-assemble.
Characteristics of packed tower
Compared with plate column, packed column has certain advantages,
especially in recent years, a variety of new and efficient packing
has been developed, which has more prominent advantages and wider
application range. Its specific characteristics are as follows:
1. The pressure drop is very low, which can be used in vacuum
distillation and other operating systems with limited pressure
drop.
2. With the development of new high efficiency packing, the
production capacity (allowable gas velocity) and efficiency of
packed tower are equal to or exceed those of plate column. Many
units at home and abroad use new packing to transform plate column,
which greatly improves production capacity and efficiency.
3. Flexible operation.
4. It can deal with foaming system.
5. General fillers are easy to be blocked by suspended solids in
the liquid, while some grid fillers with large void fraction have
self-cleaning effect under high gas velocity scouring, and are not
easy to be blocked, and their heat transfer performance is better
than that of baffles.
6. The material selection of fillers is wide, such as metal,
plastic, ceramic, graphite, etc., which is suitable for wider
chemical system and operating system.
7. Small liquid holding capacity, suitable for the treatment of
heat sensitive materials.
8. The total investment cost of small tower (diameter ≤ 0.6m) is
lower than that of plate tower, but the investment cost of large
tower is higher.
9. The heat exchange in the middle of the tower is inconvenient.
10. It is difficult to draw out the side line and the structure is
complex.
11. High requirements for initial gas-liquid distribution.
The process control is difficult because of its small liquid
holding capacity and sensitivity.
Wire mesh structured packing SS316L in production
Welcome your inquiry about Hualai structured packing any time!