|
[China]
Trade Verify
Address: No.117 Fengshen Avenue, Xiuquan Street, Huadu District, Guangzhou,China
Contact name:Jacky
Guangzhou Ruihe New Material Technology Co., Ltd |
|
Verified Suppliers
|
|
|
Phone Case Good Resilience High Tear Gas Phase Silicone Rubber
Flexible Translucent General Purpose Extrusion Silicon Rubber Tube
Suitable for the surface coating of PC mobile phone sets.
| Appearance | Hardness | Density g/cm³ | Resilience % | Tensile strength Mpa | Tear Strength % | Line shrinkage % | |
| RH4022 | Translucent | 41 | 1.14 | 60 | 11.5 | 22 | 3.3 |
| RH5022 | Translucent | 51 | 1.15 | 60 | 11 | 25 | 3.3 |
| RH6022 | Translucent | 61 | 1.19 | 50 | 10 | 25 | 3.2 |
| RH7022 | Translucent | 71 | 1.21 | 50 | 9 | 25 | 3.1 |
| RH8022 | Translucent | 81 | 1.23 | 50 | 7 | 20 | 2.9 |
Extrusion tube
Extrusion seal strip
Wire and Cable
Calendered silicone sheet
1. 20kg barrel one set A+B part 40kgs
200kg barrel one set A+B part 400kgs
2. It is available in 20kg pails and 200kg drums.
1. What's silicone products you are making?
--liquid silicone rubber, silicone rubber, silicone oil; Platinum agent: -- According to different silicone molds, our silicone has different viscosity, and cause different hardness, density to meet the requests from client.
2. Do you offer free sample to client?
--Yes, we can provide the sample for test.
3. How about the quality control in your factory?
--We have professional QC team. --Each batch of silicone rubber must be tested by our safe quality examination system.
4. How to remove the bubbles during my mould making?
--After mixing liquid silicone with curing agent, please put the material into vacuum machine to take off the bubbles.
5. How to get good silicone mould to use longer time?
--The best way is:
1, Please choose the right liquid silicone according to your products.
2, Don't use any silicone oil in mold making, because it can make the silicone mould become too soft to use.
3, Silicone mould can be used longer after the whole silicone mould fully cured, so it's better to wait 2 hours after mould finished.
6. Why silicone rubber add curing agent after mixing a lot of bubbles?
--This is normal physical phenomena. The liquid will produce a large number of bubbles in the mixing time, so, it must pass through the vacuum exhaust bubble treatment.
If you need to know the prices of our silicone rubbers, please contact us. We do not provide prices in website because prices fluctuate for many reasons.
