INSTALLTION of Protection from oil and water
(1) Next, the servo motor is not waterproof (IP44). Do not subject
the servo motor to oil and water.
Especially for the HC-MF / HC-KF / HC-AQ / HC-KFS / HC-MFS and
HA-FF series, do not subject the
shaft-through portion to oil.
(2) When the gear box is mounted horizontally, the oil level in the
gear box should always be lower than
the oil seal lip on the servo motor shaft. If it is higher than the
oil seal lip, oil will enter the servo motor, leading to a fault.
The HC-MF / HC-KF / HC-AQ / HC-MFS and HC-KFS series servo motor is
not equipped with an oil seal and cannot be used with the gear box
as described above. Oil should be shut off on the gear box side.
(3) When installing the servo motor horizontally, face the power
cable and encoder cable downward. When installing the servo motor
vertically or obliquely, provide a trap for the cable.
(4) Do not use the servo motor with its cable soaked in oil or
water. (Figure on the right)
(5) When the servo motor is to be installed with the shaft end at
top, provide measures so that it is not
exposed to oil and water entering from the machine side, gear box,
etc.
(6) If the servo motor is exposed to oil such as coolant, the
sealant, packing, cable and others may be
affected depending on the oil type.
(7) In the environment where the servo motor is exposed to oil
mist, oil, water, grease and/or like, the
servo motor of the standard specifications may not be usable.
Contact us.
(8) In the case of the servo motor with oil seal, the oil seal may
sound during operation. It poses no
problems in function.
Servo amplifier model
MR-H60A(N)
MR-H100A(N)
MR-H200A(N)
MR-H350A(N)
MR-H500A(N)
MR-H700A(N)
Servo amplifier model *20 *21
MR-J3-60A
MR-J3-100A
MR-J3-200A
MR-J3-350A
MR-J3-500A
MR-J3-700A
