SGMS-20A6AB Yaskawa Industrial Motor Constant Power Output Modular

AC Servo Motor SGMAS-01ACA2B NEW YASKAWA ELECTRIC 100W 200V​

Load Moment of Inertia

The size of the allowable load moment of inertia of a servomotor depends on the capacity, and is limited to 5 to 30 times the motor inertia. This value is provided strictly as a guideline and results may vary depending on servomotor drive conditions

An overvoltage alarm is likely to occur during deceleration if the load moment of inertia exceeds the allowable load moment of inertia. SERVOPACKs with a built-in regenerative resistor may generate a regeneration overload alarm. Take one of the following steps if this occurs.

• Reduce the torque limit.
• Reduce the deceleration rate.
• Reduce the maximum motor speed.
• Install an externally mounted regenerative resistor if the alarm cannot be cleared. Contact your Yaskawa Application Engineering Department.

QUICK DETAILS

1. Power : 100W
2. Rated Speed:3000 1/min
3. Rated Current : 0.91 A

DESCRIPTION

• AC Servo Motor
• SGMSS Sigma II
• YASKAWA ELECTRIC

SEPCIFICATIONS

Regenerative resistors are not built into 200 V for 50 W to 400 W and 100 V for 50 W to 400 W SERVOPACKs. The following figures show the tentative relationship between the load moment of inertia and motor speed using an example with a load moment of inertia 10 to 30 times the load moment of inertia at the motor shaft. External regenerative resistors are required when this condition is exceeded or if the allowable loss capacity (W) of the built-in regenerative resistor is exceeded due to regenerative drive conditions when a regenerative resistor is already built in.

SIMILAR PRODUCTS

OTHER SUPERIOR PRODUCTS