|
[China]
Trade Verify
Address: Room 1102 Bld 130 Zone C LongSheng New Village Dalang Street Longhua New Dist. Shenzhen 518109
Contact name:Kelly
Shenzhen Meixin Technology Co., Ltd. |
|
Verified Suppliers
|
|
|
Limplus Mould Cleaning Industrial Ultrasonic Cleaner 108pcs Transducer Durable LS-10801
The use of mould and die cleaning system developed by us is a high-tech, low-labour method for cleaning injection moulds and dies. The ultrasonic cleaning removes carbonization, mould release, gassing, flashing, and other residues from moulds and dies in as little as 15-20 minutes.
Limplus mould and die cleaner have been proven effective on steel, chrome-plated steel, nickl-plated steel and so on.
Some of the highlighting features of mould and die cleaning system are:
1. Reduce maintenance down time
2. Eliminate hand cleaning
3. Replace troublesome solvents and harsh abrasives that can damage moulds
4. Improve cleaning effectiveness as chemistry and ultrasonic gently clean
5. Even intricate designs and patterns
6. Decrease labour expenses.
Specifications:
| Model | LS-10801 |
| Tank size | 1200x700x600mm |
| Unit Size | 1380x880x900mm |
| Ultrasonic power | 5400W |
| Heating power | 9000W |
| Timer | 1~99hours |
| Temperature | 20~80C adjust |
| Material | SUS304 / SUS316L |
| Voltage | AC220V/AC380V 3phase |
| Optional | Rinsing tank, Drying tank, filtration system |
Remark: bigger or smaller capacity, rinsing tank, drying tank are available from us.
Ultrasonic cleaning gives the following advantages:
| 1 | Short wash process leading to reduced time spent in cleaning |
| 2 | No manual labour required. An operator is not required when the machine is cleaning the mould |
| 3 | High levels of cleanliness give longer life in production |
| 4 | No abrasion of precise edges and surfaces gives longer mould life |
| 5 | No solvents needed because of aqueous process |
| 6 | Suitable for all moulds, large and small |
| 7 | Machinery is simple and easy to use |
The ultrasonic cleaning of molding equipment, such as injection molds and blow molds, will require the same three processing stages as any other type product when cleaned with aqueous cleaning agents; the Ultrasonic Cleaning Stage, where contaminants are removed from the product, the Rinsing Stage, where the detergent residues are removed from the product, and the Drying Stage, where rinse water is removed from the product. Although the 3 main stages are the same, the ultrasonic cleaner must be properly configured with additional equipment to clean these items successfully.
