Series of long life aviation obstacle lights microcomputer chip
control, automatic light control flash. There are two kinds of
light sources to choose from, the lamp adopts 130 mm polyacrylic
Fresnel plastic lens, sunlight resistance, good
anti-aging,beautiful appearance and good security, perfect high
intelligence computer chip to ensure the best match of light
control, flash,bright cycle, soft light to eliminate light
pollution. Lamp shell has senior aluminum alloy casting, watertight
structure, small size, often light, dry installation. The lamp's
switch, flash, voltage stabilization functions are completed by the
lamp's internal light controller and computer chip. Light device in
the requirement of multiple synchronous joint flashing synchronous
signal line or with control box. The light device and general
aviation obstacle lights compared to it has more energy saving,
longer life, lighter, more economic characteristics.
The aviation obstacle light is a special light for the
identification of obstacles and belongs to the category of aviation
lighting equipment industry. In order to have a difference with the
general lighting, aviation obstacle lights are not always on but
flashing, low light intensity aviation obstacle lights are always
on, medium light intensity aviation obstacle lights and high light
intensity aviation obstacle lights are flashing, the flashing
frequency is not less than 20 times/minute and not more than 60
times/minute. The function of the aviation obstacle light is to
show the outline of the structure, so that the aircraft operator
can judge the height and outline of the obstacle and play a warning
role.
4, for more than 105 meters of ultra-high objects, facilities or
cable towers, roof towers, etc., should be set at the top of its
medium light intensity A-type obstacle lights, and white flash, its
lower set a layer of red medium light intensity B-type obstacle
lights.
5, higher than 150 meters of ultra-high objects (such as radio and
television towers, large cross-line bridges, etc.) should be set at
the top of its high light intensity A-type obstacle lights, and
should be used in the medium and high light intensity obstacle
lights with.
6, ultra-high voltage transmission line tower should be set high
light intensity B type obstacle light, and for three layers of
synchronous flash. Position for the tower top, cable sagging lowest
point and the middle two positions, and need to be set along the
cable direction in the tower outside.
7, for a chimney or other similar nature of the building, the top
of the barrier light must be located in the top 1.5-3 meters
between, taking into account the chimney on the light pollution,
the barrier light can be installed in the chimney mouth below 4-6
meters of the part (see the national standard excerpt).
8, no matter which kind of obstacle light, its in different height
obstacle light quantity and arrangement, should be able to from all
directions can see the object or object group outline, and consider
the obstacle light synchronous flashing, in order to achieve
obvious warning effect.