|
[China]
Trade Verify
Address: No.18 Shijing Mingcheng Road, Pingshan District, Shenzhen City, Guangdong Province, China
Contact name:Joan Deng
Shenzhen Huaxing New Energy Technology Co.,Ltd |
|
Verified Suppliers
|
|
|
5KWh 48V 100Ah Lithium Battery Pack For Home Energy Storage System Equiped With 5KW Inverter
48V 100Ah 5KWh LiFePo4 Battery and5KW inverter Specification
| Battery parameters | Item | Cell | Battery pack |
| Parameter | 3.2V 6Ah | 51.2V 100Ah | |
| Quantity | 288 | 1 | |
System capacity
| 5kWh (can be parallel to 10KWh) | ||
| Overall system efficiency | 90%±5% | ||
| DOD | 80% | ||
| Actual available capacity | ≥4.6kWh | ||
| Cycle life | Over 4000 cycles(0.3C cycle, 25℃(capacity retention 80%) | ||
| Continuous charging current(A) | 20A(adjustable) | ||
| Continuous discharge current(A) | 40A (adjustable) | ||
| Full power charge and discharge rate | 0.3 C | ||
| energy capacity of battery | 25°C 4kWh (100% DOD @ 1C rate) | ||
| - 20°C 3.6 kWh(100% DOD @ 1C rate) | |||
| Storage temperature | < 45°C is the best storage temperature | ||
| Self-discharge | 25°C,≤5% per month | ||
| IP rating of enclosure | IP55 | ||
| Inverter Specification | |||
| Model | 5.5kW | ||
| Parameters | Continuous power:5.5(KW) Peak power:11(KW)5S | ||
| Nominal rated voltage:(Vdc)51.2 (Lithium iron) | |||
| Charging current:(A)0~80(adjustable) | |||
| Cut-off voltage:(V)58.4 | |||
| Maximum discharge current:(A)100(adjustable) | |||
| Grid voltage range: 230VAC±5% Input maximum current:100A Frequency:50Hz | |||
| Inverter voltage range:230Vac±5%(Inverter mode) Frequency:50/60Hz±1%(Automatic detection) Output waveform:Pure sine wave Efficiency:>90%(88%resistive load) Protection function:Over voltage and under voltage protection, overload protection, short circuit protection, over temperature protection. | |||
Battery pack interface
Working principle
Installation Location:
Consider the below points before selecting installation location:
1 There are no flammable or explosive materials
2. The floor is flat and level.
3 Install the system in a visible location so that user can read the LCD display parameter at any time.
4 The area is completely waterproof
5 Make sure there is 20 cm distance from the two side, 50 cm distance from bottom of the unit.
6 The ambient temperature is within the range from 0°C to 55°C.
7 The temperature and humidity are maintained at a constant level.
8 The installation areas shall avoid of direct sunlight
9 The distance from air outlet of inverter is more than 0.5 meters.
10 The distance from heat source is more than 2 meters.
11 There is minimal dust and dirt in the area.
