CREE Ultra High Intensity LED Helipad Landing Lights Die Casting Aluminum IP68

Heliport Inset light is always be installed at locations where the lights are frequently knocked down by aircraft or maintenance vehicles. It could be used as Aiming point light, perimeter light of FATO(Final approach and take-off areas), TLOF (Touchdown and lift-off areas), taxiway, Flight path alignment guidance lighting, etc. The emitting color is green or yellow or white or blue. 8inch International standard mounting for aerodrome inset light.

Compliance 

ICAO Annex 14 Volume ǁ Heliports 5.3. 

FAA AC 150/5390-2B Heliport Design Guide 

CAAC MH 5001—2013 Aerodrome technical standards 

CAAC MH 5013—2014 Technical Standards of Civil Heliports

Electrical

Ultra high intensity CREE LED as light source saving power consumption and maintenance,

95% less power than equivalent incandescent light .

Power supply available in AC(110-240VAC), DC48V

Physical 

Pressure resistance lens allowed the vehicles go through on light 

Die-casting aluminum covered by color powder coasted which have good corrosion protection and load bearing. IP68 waterproof ensure light work fine underground

Optional 

Infrared LED for pilot using NVG(Night Vision Goggles)  Controller for power supplying and turn ON/OFF light  VHF pilot to ground remote control Light intensity adjustable

Certificate

Shipment