Test chamber has the dimension of 1,000±100(W) x 2,000±100(D) x
4,000±100(H) mm.
The bottom surface of the test chamber is higher than the ground
while the rear side is supplemented with insulated material to
insulate it from heat.At the lower section of the test chamber,
there is a 800±20(W)x 400±10(D) sized hole at the 150±10mm position
from the front side of the chamber to supply the air.
There is a 300±30(W)x1,000±100(D) sized exhaust hole at the rear
corner of the top section of the test chamber to allow emission of
the smoke during the test.
A flame trap is installed at the front side of the burner of the
vertical flame spread tester to prevent backfire by propane to
ensure the utmost safety.
Unlike the conventional IEC60332-3 equipment, the vertical flame
spread tester records all control and test conditions with the
computer to add user friendliness.
If stop the excessive combustion test due to Water Spray device
installed for extinguish.
The program on the requirement on standard and 70,000Btu/h can be
program.
Wide stainless steel ladder dimensions: 500(W) ×3, 500(H) mm.
Standard stainless steel ladder dimensions: 800(W) ×3, 500(H).
Two sets of standard propane burner and venturi mixtures.
Follow the standard category can program for select a test.
How does fire retardant work?
Fire retardant contains salts (typically fertilizers) that alter
the way wildfires burn, decreasing fire intensity and slowing the
advance of the fire, even after the water in the fire retardant has
evaporated. The water in long-term fire retardants serves primarily
to aid in uniform dispersal of the chemical over the target area.