Home Companies SKYLINE INSTRUMENTS CO.,LTD

IEC60695-11-03 Fire Testing Equipment Single Cable Vertical Flammability Tester

Contact Us

[China]

Trade Verify

Address: No.1802 Room 6# Building Universal Commerce Center Nancheng District Dongguan Guangdong China

Contact name:Ivy Xie

SKYLINE INSTRUMENTS CO.,LTD

Verified Suppliers

Trust
Seal
Verified
Supplier
Credit
Check
Capability
Assessment

IEC60695-11-03 Fire Testing Equipment Single Cable Vertical Flammability Tester

Country/Region	china
City & Province	dongguan guangdong
Categories	Power Cables

Product Details

IEC60695-11-03 Single Cable Vertical Flammability Tester

Product introduction

Single Cable Combustion Tester is the most widely used and lower cost of cable fire performance test equipment, which can meet the standards IEC 60332-1-1:2004 in the provisions of technical indicators and requirements. Single cable combustion Tester is used to test the flame retardant property of the cable's insulating layer under abnormal conditions such as overheat and overcurrent. It can be used in vertical cable or fiber flame spread test, also can be test the state of flaming droplets during combustion.

Application

Applies to check thesingle insulation wire and cable vertical spreading test which total section area less than 0.5mm2

Standards

According to IEC60332-1-1:2004, IEC60332-1-2:2004, IEC60332-1-3:2004, EN50265-1, EN50265-2-1

Main parameters

Vertical burning chamber	W300xH1200xD450mm
Gas	Use high purity propane gas or liquefied petroleum gas (provide by user-self)
Specimen length	600±25mm
Area of specimen	Total section area less than 0.5mm2
Testing temperature	This device is located in a stuffiness room and the temperature keeping the 23±10℃ for testing
Burning time	continuously setting between 0.1-999.9S, during the setting time flame could continuously burning the specimen
Control function	Switch can choose to be manual or automatically according to the actual needed
Gas flow range	0.1-1L/min
Area flow range	0.1-1m3/h
Burner	500W for standards power, 125±25mm for total height of the flame
Temperature measurement system	according to GB/T5169.14-2007 and IEC60695-11-03 standard requirements, including temperature copper (10g), K type thermocouple and diameter is 0.5 mm with stainless steel sheathed, stopwatch and thermometer etc.

Automotive Single Wire.pdf

What is a Vertical flame Test?

A test specimen is positioned vertically above a controlled flame and exposed for a specified period of time. Following exposure, the flame source is removed. Measurements are made on the length of time that the specimen continues to flame and the time afterglow continues after the flame source has been removed.

What is the flame exposure test for a cable?

Table 1: UL Control and Instrumentation Cable Standards Containing Vertical Flame Tests The UL Flame Exposure test of UL 1685 measures the flame spread in groups of cables in a steel ladder tray. The tray is 12 inches wide, 3 inches deep and 96 inches long.