|
[China]
Trade Verify
Address: Zhongdaliang Industrial Zone, Anping County
Contact name:Amy
Anping Yuanqiao Petrochemical Equipment Co., Ltd |
|
Verified Suppliers
|
|
|
Copper knitted wire mesh products for industrial, especially Copper Gas Liquid Filter for cleaning and filtration. Copper knitted wire mesh's biggest advantage is its unique construction. Knitting produces an interlocking-loop pattern. In this configuration, each loop is an integral part of its neighbors with each supporting the other. When a mesh or mesh element is compressed, stretched or bent, and provided that exertion is not past the material’s yield point, this integrity allows the element to spring back to its original form.
| Product Name | Copper Knitted Wire Mesh | Key Words | Knitted Wire Mesh |
|---|---|---|---|
| Material: | 99.9% Copper Wire | Wire Type: | Round Wire, Flat Wire |
| Mesh Width: | 4in, 5in, 6in, As Per Order | Other Name: | Copper Gauze |
| Mesh Status: | Plain, Or Crimped | Strand Number: | 1, 2 Or 4. |
Copper mesh for wildlife stopper can control the animal ,for example snake ,rodent ,the most important is give you a security environment ,at the same time keep green ,because it is Rohs material .
Steps to clean the screws and barrels efficiently with copper gauze and grease.
Step 1: Use a purging compound to clean the extruder. Then use small ball of copper mesh with some silicone grease on it to clean the die face. Also please clean the valve when it is still hot.
Step 2: Remove the die from the extruder head. It is best to clean it by silicone coated copper gauze forced through the die with a wooden dowel.
Step 3: Pull back and forth the copper gauze to complete the cleaning after it pass through the die.
Step 4: Make sure that no residual trace of adhered plastic is left, nor causing a scratch on the metal surface, so the die is thoroughly clean.
Step 5: Remove the hot screw partly, wrap the copper gauze with silicone coating 3 times around the screw, pull back and forth to do the cleaning.
Step 6: Keep sliding the copper gauze when removing the screw out of barrel slowly, until the screw is clean. It takes only 5 minutes for step 5 and 6 operations.
Step 7: Wrap copper mesh at end of a long rod and pass it through the barrel. Then, chuck the rod into power drill, insert fresh gauze and pass back and forth through barrel until clean.
Step 8: Please do all the operations with silicone grease coated copper mesh. Now all parts is clean and ready for reassemble
Copper has good electrical conductivity, thermal conductivity, corrosion resistance and ductility and other physical and chemical properties.Electrical and thermal conductivity is second only to silver, pure copper can be drawn into very fine copper wire, made into very thin copper foil.The fresh cross section of pure copper is rose-red, but after the formation of copper oxide film on the surface, the appearance is purplish red, so it is often called copper.
