Active Member
|
[China]
Address: Room 301-302, 3rd Floor, Comprehensive Building, Tsinghua Information Hi-tech Park, North Science Park, Nanshan District, Shenzhen ,China 518052
Contact name:Ava Tian
Shenzhen Kingwo IoT Co.,Ltd |
|
|
Features:
1. Magnets for easy installation
2. Battery can last for 5 years
3. Built in light sensor for removal alarm
4. Bulit in G-sensor for motion alarm and collision alarm
5. Ultra low consumption
6. Temperature monitor
7. IP67 waterproof
8. GPS, LBS and Wifi Position
Specifications:
| Physical | Dimension | 81mm*51mm*31mm(L*W*H) |
| Weight | 192±7g | |
| Cellular | Communication module | Quectel BG96 |
| Frequency | Working frequency: • Cat M1: LTE-FDD
B1/B2/B3/B4/B5/B8/B12/B13/B14/B18/B19/B20/B25/B26*/B27/B28/B66/B85 | |
| GPS | Channels: 50 Sensitivity: -147dBm Position accuracy:5-10m Accuracy: 5m CEP Cold start: <27s Hot start: <1s | |
| Power | Battery | Disposable Lithium-ion battery and (3.6V,8100mAh) and ultra-low discharge rate:less than 1%, store one year below 25℃ |
| Power consumption | Average working current <100mA; Power save current <10uA; | |
| GSM antenna | Internal High Gain | |
| GPS antenna | Internal High Gain | |
| SIM | Microsim | |
| Indicator | 2 status LEDs, Green: GPS, Red:Celluar | |
| Environmental Parameter | Working Temperature | -20℃ ~ +70℃ |
| Humidity | 5% ~ 95% (no fog) | |
| Ingress Protection Rating | IP67 | |
| More features: |
• History data store
When the device enter into blind zone when in sleep mode, it will store the trace data according to the preconfigured time interval and it will upload the data in the blind zone to the backend when the cellular network recovers
• LBS
The default position mode is by GPS, however when device enters into the blind zone and GPS cannot be fixed, the device will switch to LBS position, LBS provides the reference wlocation hich is might not accurate
• OTA commands from backend
Since the wake up of the device is short, it is hardly to receive SMS , to ensure the command sending efficiently, we suggest an OTA commands to be sent from the platform, when the device is online, the backend will automatic send this command, to make sure the commands is properly received.
• Tracking
The default setting is upload once a day, the upload packet information includes: Position status, longitude and latitude, network signal Strength, satellite numbers, battery voltage etc, the upload interval can be configured either by SMS or through tracking platform software
Exhibition:
Customer Feedback:
