Active Member
|
[China]
Address: Room 301-302, 3rd Floor, Comprehensive Building, Tsinghua Information Hi-tech Park, North Science Park, Nanshan District, Shenzhen ,China 518052
Contact name:Ava Tian
Shenzhen Kingwo IoT Co.,Ltd |
|
|
NT07E is an eMTC NB CatM1 Let-M Asset GPS Tracker with 8100Mah battery, compact size, and built-in GPS/GSM antenna, low cost, low data consumption. It’s ideally suitable for Asset tracking market.
Features:
1. No wired needed, easy for installation
2. Built in G-sensor Temperature monitor
3. Built in light sensor
4. GPS+AGPS+LBS+WIFI position
5. Battery can be last for 5 years based on reports one GPS position every day
6. Ultra low consumption
7. Strong magnetic for easy installation
8. Built in strong magneticSupport tamper proof alarm
Specifications:
| Physical | Dimension | 81mm*51mm*31mm(L*W*H) |
| Weight | 192±5g | |
| Cellular | Communication module | Quectel BG95 |
| Frequency | Working frequency: • Cat M1: LTE-FDD
B1/B2/B3/B4/B5/B8/B12/B13/B14/B18/B19/B20/B25/B26*/B27/B28/B66/B85 | |
| GPS | Channels: 50 Sensitivity: -147dBm Position accuracy:5-10m Accuracy: 5m CEP Cold start: <27s Hot start: <1s | |
| Power | Battery | Disposable Lithium-ion battery and (3.6V,5400mAh) and ultra-low discharge rate:less than 1%, store one year below 25℃ |
| Power consumption | Average working current <100mA; Power save current <15uA; | |
| GSM antenna | Internal High Gain | |
| GPS antenna | Internal High Gain | |
| SIM | Microsim | |
| Indicator | 2 status LEDs, Green: GPS, Red: EMTC | |
| Environmental Parameter | Working Temperature | -20℃ ~ +70℃ |
| Humidity | 5% ~ 95% (no fog) | |
| Ingress Protection Rating | IP67 | |
| More features: |
• WIFI position
The terminal is with built in WIFI Chip, when it starts, the WIFI Chip will automatically connects to the WIFI hotspot nearby and filter the hotspot info then select the WIFI hotspots with strongest signal, the terminal will pack those hotspots info and saved into the pack that will be uploaded, after the backend receives information from the terminal, it will interpret the WIFI info and acquire the current location info according to the WIFI position server.
The default setting is WIFI priority, once it detects WIFI Hotspot, it will upload WIFI info only , and do not use GPS, if WIFI is not detected, it will use GPS to position
• LBS
The default position mode is by GPS, however when device enters into the blind zone and GPS cannot be fixed, the device will switch to LBS position, LBS provides the reference location which is might not accurate
• OTA commands from backend
Since the wake up of the device is short, it is hardly to receive SMS , to ensure the command sending efficiently, we suggest an OTA commands to be sent from the platform, when the device is online, the backend will automatic send this command, to make sure the commands is properly received.
• Tracking
The default setting is upload once a day, the upload packet information includes: Position status, longitude and latitude, network signal Strength, satellite numbers, battery voltage etc, the upload interval can be configured either by SMS or through tracking platform software
Q1. Can you help for design?
A:Yes,we have our own software and hardware engineer,you can give your idea to us,we can assist the design work.Provide sample for your reference.
