|
[China]
Trade Verify
Address: Building A2,Hutang Industrial zone,Lingdao Rd,Wujin District,Changzhou,China.Zip:213162
Contact name:Annie
CHANGZHOU JKONGMOTOR CO.,LTD |
|
Verified Suppliers
|
|
|
BLDC Driver For 120W Brushless Dc motor 0A - 8A CE ROHS Approved
Parameters | Min | Rated | Max | Unit |
Hall effect angle | 120°/240° |
| ||
Power supply input voltage | 12 | 24 | 30 | V |
Driver current output |
| 5 | 8 | A |
Motor speed | 0 |
| 20000 | rpm |
Hall signal voltage | 4.5 | 5 | 5.5 | V |
Hall signal current |
| 20 |
| mA |
External potentiometer |
| 10K |
| Ω |
Mark | define |
DC+/DC- | Power supply input (DC12V~DC30V)don’t make mistake for + and - |
U,V,W | Motor leading wires connect thick wires |
Hu,Hv,Hw | Hall signal leading wire connect (thin wires Hu, Hv, Hw) |
REF+ | Hall power supply + (for motor hall input +5V) |
REF- | Hall power supply - ( hall ground connect this port) |
VCC | External potentiometer power supply port ( just can use for potentiometer, can't for other external circuits) |
SV | External potentiometer terminal ( See note speed regulation ) |
COM | common port ( Low level ) |
F/R | Direction: dangling or high level forward, low-level inversion note 1 |
EN | Enable: high level/stop low-level/run note 1 |
BRK | Fast brake: high level/stop low-level/run note 1 |
Note 1: F/R and COM disconnect the motor forward, closed for reversal.EN
closed with COM for running, disconnect for standby.BRK and COM
side closed to run, disconnect for the brake.
When using BRK control, shorter EN received COM port, when using EN
control, shorter BRK received COM port.
Speed regulation way (see instructions):
A. the internal potentiometer RV can be used for motor speed
adjustment
B. the external potentiometer can be used for motor speed
adjustment
C. the external analog input voltage can be used for motor speed
adjustment
D. the external PWM input can be used for motor speed adjustment:
pulse duty ratio from 10% to 90%
Linear speed adjustment, pulse frequency, 1 k - 10 KHZ, pulse
amplitude: 5 v
Wiring note: note that the sequence of wiring UVW three-phase motor and sale of hall signal lines and the connection sequence of the power cord
power parameter setting : :
Note: to prevent electric pilot time to super power operation and damage Motor, please according to the above numerical combined with electrical power Properly set.Great changes have taken place when the load and lead to electricity Actual operation power more than setting will go into the drive Protected mode.
