|
[China]
Trade Verify
Address: Building A2,Hutang Industrial zone,Lingdao Rd,Wujin District,Changzhou,China.Zip:213162
Contact name:Annie
CHANGZHOU JKONGMOTOR CO.,LTD |
|
Verified Suppliers
|
|
|
18V~50VDC 0A-35A Brushless Dc Motor Driver JKBLD300 For 0 - 300w Bldc Motor
Description:
The JKBLD300 is a high performance, cost-effective 3 phase BLDC motor drive
which can provide power output 300VA max. The design is based on advanced DSP
technology and feature high torque, low noise, low vibration, PID speed loop, PID
current loop, over current protection, over load protection.
Electrical Specifications:
| Parameter | Min | Rated | Max | Unit |
| Motor Hall Sensor Angle | 120°/240° | |||
| DC Power Input | 18 | 48 | 50 | V |
| Drive Current Output | 0 | 15 | 35 | A |
| Suitable Motor Speed | 0 | 20000 | rpm | |
| Hall Sensor Voltage | 4.5 | 5 | 5.5 | V |
| Hall Sensor Current | 20 | mA | ||
| External Potentiometer | 10K | Ω | ||
Connection Definition:
| Mark | Definition |
| DC+/DC- | DC Power Input (DC24V~DC48V) |
| U,V,W | Motor lead wire |
| Hu,Hv,Hw | Hall sensor lead wire |
| REF+ | Hall sensor power supply + |
| REF- | Hall sensor power supply - |
| VCC | External potentiometer power supply + |
| SV | External potentiometer |
| COM | Public (low level) |
| F/R | Direction: High level/CW Low Level/CCW |
| EN | Enable: High Level/Stop Low Level/Run |
| BRK | Quick Brake: High Level/Stop Low Level/Run |
| SPEED | Speed signal output |
| ALARM | Alarm signal output |
Speed Adjustment Instruction: A. Motor speed adjusted by the internal potentiometer B. Motor speed adjusted by the external potentiometer C. Motor speed adjusted by analog signal 0V~+5V input D. Motor speed adjusted by analog signal 0V~+10V input E. Motor speed adjusted by PWM input: Pulse duty ratio 10%-90% / Speed linear modulation Pulse rate: 1K-10K/ pulse amplitude 5V | Motor Speed Quick Response Setting: RV OP/CL Connected (user setting): PID Closed loop－Motor quick response OP/CL Disconnected (factory setting): NO PID Closed loop－Motor normal response Lead Wire Connection: Take care of the sequence of U,V,W |
Peak Power Setting:
Note: To protect the motor, set the arrow number as the same as the motor nominated power. Whenever overload occurs the drive will turn out to be the protection mode.
Mechanical Drawings:
Indicator Instruction:
| Indicator | Green | Power indicator |
| Red | Over-current, hall error | |
| Red flickering | Stall/over-heat/over-voltage protection |
