24mm X 24mm Insulation Stick Pins Self Adhesive Anti Corrosion

50mm Self-adhesive Stick Pins Mechanical fixing for insulation

Perforated Base Insulation Hanger Zinc Finish Self Stick Pin To Stick Plastic To Metal

Recommended installation for self adhesive insulation hangers.
It is recommended that you place the stick pins 300 mm apart around the edge of the area were the insulation is top be secured. 400mm apart is adequate in the centre areas of the fixing area. This spacing ensures that sag will not occur if using rock-wool type insulation and will also ensure that there are enough mechanical fixings to hold the weight of thicker rigid insulation boards.

Product Parameters

Product Usage

01 used in air conditioning pipes
02 used in glass, wooden walls;
Recommended assembly method :

1. Work surfaces should be clean and dry, free of dust, grease, oil and any other loose matter.
2. Remove the protective release paper taking care not to touch the adhesive.
3. Place the hanger in the required position and press the base against the surface to be insulated.
4. Insulation can be impaled immediately and firmly locked with fastening clips but maximum strength of adherence is achieved after 24 hours.

Product Advantages

It has anti-aging, anti-temperature sudden change, anti-corrosion, cold-resistant and heat-resistant; high bearing capacity, high pressure bearing and good tensile performance; it is not easy to deform, moisture-proof, vibration-relieving, and good thermal insulation after loading.