|
[China]
Trade Verify
Address: Block B 1307, Green Square, Huaiyin District, Jinan China
Contact name:Rose
Jinan Lijiang Automation Equipment Co., Ltd. |
|
Verified Suppliers
|
|
|
●Mechanical part:
(1) The total length of the main beam of the suction hoist is
designed to be 2000mm, and the upper part of the middle part is
welded and sealed with a plate, and the middle part is used as a
vacuum accumulator. The airtightness test is carried out after
welding to ensure no leakage. When the equipment is suddenly
powered off, it is still guaranteed to be able to reliably adsorb
the plates for at least 20 minutes, and will not cause safety
accidents such as equipment damage (the European CE standard is to
maintain 10 minutes)
(2) This equipment is equipped with 6 suction cups with a diameter
of 360mm for different sizes of glass. The position of each suction
cup on the beam is adjustable to facilitate the adsorption of a
glass of different sizes.
●Electrical part:
(1) A vacuum pressure switch and a buzzer alarm unit are installed
on the vacuum hoist. When the vacuum system pressure does not reach
the set pressure, or when a power failure occurs, the alarm unit
will control the red warning light to light up and the buzzer to
sound. , Prompt the operator to deal with it in time.
●Vacuum part:
(1) The suction hoist adopts a German oil-free rotary vane vacuum
pump, with a pumping capacity of 8m3/h, a large vacuum degree of
over 85%, energy-saving, compact and lightweight, no maintenance,
etc.;
(2) The whole set of equipment is equipped with 6 vacuum suction
cups, multi-point adsorption to ensure that the plate can maintain
a high level during the handling process without tilting;
(3) The suction cup material is nitrile rubber, with a diameter of
360mm, oil (benzene), durable, acid and alkali resistance, and can
effectively adsorb with FRP to produce a true single suction cup
level. Theoretical large suction force = effective area (physical
product * coefficient) * calculated pressure (0.6bar);
(0.18*0.18*3.14)*0.6*10000=610.416, which is approximately 610.4Kg.
According to the 4 times safety factor, the actual allowable
suction power of the suction cup is 610.4/4=152.6Kg. The total
suction power of 6 suction cups is 600kg. Note: The vacuum suction
force mentioned in the above table is calculated under 60% vacuum
degree. Under normal working conditions, the system vacuum degree
can reach more than 85%;
(4) The vacuum pressure sensor is made of Japanese Panasonic brand,
and the alarm pressure level is set to 60% vacuum;
(5) Each suction cup is equipped with a manual ball valve to
control the opening and closing, which ensures that the same
equipment can be applied to various specifications of plates;
(6) The upper and lower parts of the sucker rod are equipped with a
spring. When the plate is not flat, the spring acts as a buffer to
make the sucker evenly stressed, so as to ensure the safety and
reliability of the suction cup.
