Jinan Lijiang Automation Equipment Co., Ltd. |
Verified Suppliers
|
|
1.Overview of Horizontal glass washing machine
Glass washing machine CP-2500A used for washing and drying the upper and lower surfaces of ordinary plate glass and high quality low-e glass,it is composed of incoming segment, washing air-drying segment and outgoing segment.
1.Equip 3pairs of hairbrush roller(φ150mm), can washing the hard LOW-E glass, common coated glass and sunshine coated glass, whenwashing the coated glass, two pairs of strong hairbrush can though the air cylinder raise up, will never hurt the coated surface.
2. Transfer rubber covered roller adopt gear revolve, stable and convenience maintain, the above and bottom hairbrush roller adopt two motors for transfer motion, stable transfer, the belt are durability.
3.The metal parts of the washing section which are contact with
water, all adopt stainless material, with circulating pump, water
tank can pull out washing, have three levels washing, when request
the higher washing effect, two sets of hairbrush roller at behind
have to use running water(purified water can get the better
effect).
The machine top part equip the stainless water dish, transfer
rubber covered roller can clean by itself at the revolve
process;also with the sprinkler systems can wetting the glass
surface before the glass enter the washing part, improve the
washing effect.
4.Machine transmission are adopt vulcanized rubber cover roller
structure (prohibit acidic liquid get in touch), washing part,
drying part whole lifting automatically, the maximum lift range is
400mm, in order to adapt washing different glass
thickness,continence for cleaning and replace the hairbrush.
5.Drying part, air drying system equip two pairs of air knife, a
pair of straight air knife and skew air knife cooperate
application, Equip high pressure blower 22kw, air intake through
air filtering, large wind power, good drying effect, whole bellower
is install on the top of the drying part, follow the washing and
drying part lifting automatically, to ensure the after washing
products can meet the requirement of the drying level. high
pressure blower can completely drying the glass surface, large
lateral wind power, good air drying effect.(two cold wind air
knife, no need to heat). Keep after washing product can meet the
requirement of the drying level, the upper air knife through
controlling system adjust lifting, inside maximum opening width is
400mm, is convenience to adjust the air knife height and degrees,
improve the drying effect.
6.The machine frame and others sheet metal parts which are not
touching water, spray the senior mechanical paint after through the
special technology processing. The paint with strong adhesion,
bright durable surface.
3. Technical parameters of glass washer
Maximum glass width | 2500mm (effective maximum: 2650mm) |
Minimum glass specification | 400mm×400mm (limited to single row on left and right sides) |
Glass thickness | 3mm-25mm (digital display) |
Speed range | glass thickness within 3-25mm Vmax=1-12m/min |
Main drive, brush speed regulation method | frequency control |
Table height | 900±25mm |
Total power | 42KW(water-bearing wind heating: 15KW) |
Water source | self-circulation, tap water (according to civil water standards) and deionized water water supplement (deionized water equipment shall be provided by the buyer) |
Power source | 380V 50Hz |
Dimensions (length × width × height) | approximately 6260*4800*3100 |
Weight | 3940kg |
Main drive motor | Zhejiang province |
Brush motor | Zhejiang province |
High pressure air blower | Guangdong province |
The water pump | Shanqing |
brush | Anhui province |
Rubber roller | Guangdong province |
Frequency converter | VEICHI/Rexroth |
Electric parts | Schneider |