4 Port POE Din Managed Network Switch Gigabit Based Mini 48V Dual Input

Olycom Gigabit Industrial Managed Ethernet Switch with POE

Key Features of 4 port POE switch

• Support power on POE IP cameras through the wireless access point (AP) of 5 categories of Ethernet cable.
• IEEE 802.3af/at power on to 1 ~ 4 RJ45 ports
• 4 x 10/100/1000Mbps Auto-sensing RJ45 ports
• 2 x 1000Mbps SFP fiber port
• 4 KV Ethernet surge protection, adapt to a harsh outdoor environment
• Support Auto MDI/MDIX
• Flow control mode: full duplex with IEEE 802.3x standard, half-duplex with Back pressure standard
• IEEE 802.3 10Base-T and IEEE 802.3u 100Base-TX compliant
• A store-and-forward switching mechanism
• Operating environment temperature: -40 ° ~75 ° c
• meet IP40 protection degree and EMC industrial grade requirements
• DIN rail installation

Technical information of mini poe switch

Management Features of industrial network poe switch

1. Support ITU-T G.8032 Ethernet Protection Ring(EPR)
2. Supports CLI for quick and easy configuration of key management functions
3. Using RMON to Effectively Improve Network Monitoring and Prediction Capabilities
4. Support port locking based on MAC address to prevent illegal intrusion
5. DHCP Option 82 is used to assign IP addresses with different strategies
6. Support ERPS standard ring network protocol
7. IGMP Snooping and GMRP filter multicast traffic
8. Support port-based VLAN, IEEE 802.1Q VLAN and GVRP protocol, easy network planning
9. Support SNMPv3, IEEE 802.1X, HTTPS and SSH to enhance network security
10. Support TACACS+
11. Realize automatic alarm through E-mail and relay output
12. Reset: Support restart and restore default configuration
13. Support port mirroring
14. Supports Ethernet/IP for device management and control
15. Support multicast, broadcast storm control
16. Bandwidth management: support port aggregation, port speed limit, broadcast storm suppression
17. Support QoS and ToS/DiffServ for traffic control and management
18. Support link aggregation to optimize bandwidth utilization

Dimension of managed gigabit switch

More Photos of industrial network switch

Company Profile

• What we do

We manufacture and market fiber optic connectivity devices.

We provide solutions and services of industrial fiber switch, fiber to copper media conversion, Ethernet networking, and CCTV video surveillance.

• Who we are 

ISO9001 Quality System

We got necessary certificates to support our products.

Full-Spectrum environment and electrical testing of all product design

• Production steps

Welding: Weld the necessary components

Cleaning: To avoid any possible dysfunction due to dust or scraps on the PCB boards.

Assembling: Builds up components of a product, like panels, screws, PCB boards.

Testing: To make sure the product is basically working fine after assembling

Aging: To check if the product can work smoothly for long time without any minors such as LED indicators, voltage. This will usually last for 24 to 48 hours.

Testing: To test if the product can process data or video signals correctly. Any data loss? Transmission rate correct? Any data packet failure? Such questions would be verified in this procedure.

QC testing: This is the third and also last check of product quality. If it goes good, our packing staff will pack it up according to customer requirements and attach to the packing box a product label.

When all above is done, the product will go to market.