|
[China]
Trade Verify
Address: Room 202, Building 4-2, No. 539, Shibei Industrial Road, Dashi Street, Panyu District, Guangzhou, Guangdong
Contact name:Tessa Huang
Guangzhou HongCe Equipment Co., Ltd. |
|
Verified Suppliers
|
|
|
IEC60335-1 Clause 25.15 Power Cord Flexibility Tester With 2 Working Stations
Product information:
The test appliance conforms to IEC60335-1 Clause 25.15. It is used to test the power cord tension and torque at the terminal two trials of the appliances which are with a power cord, and intended flexible cord permanently connected to the fixed wiring and other household electrical appliances, medical equipment, checking whether the clamping device is secure.
The test times can be preset (up to 999999 times), the test automatically conducted, automatic calculate the test times, when the test reaches to the preset number of times, the device will automatic shut down and produce a signal of the ending test, the load on and off test can be done if connect with a load.
Technical parameters:
Power supply | AC220V, 50HZ |
Test station | 2 working station,with two sets of fixtures |
Bending angle | 0~360° adjustable |
Bending rate | 10～60rpm |
The load weight | 5N, 10N ,20N , 113G, 284G, 2pcs for each |
Counter | 2 independent counters for corresponding station, one total counter, counting times:0 to 999999 |
Action principle | Adopt motor servo drive system, the swing angle and speed regulation of high precision |
Control | Using visual touch-screen display and PLC control, direct viewing operate in control and parameter settings |
Disconnection instructions | Indicator with audible alarm |
Dimensions | L870mmXW610mmXH820 |
Preparation:
Sample Installation: Mount the non-rewirable plug (test sample) on the fixture and fasten it. Install requirement is to make the lateral displacement of the cord and load to be minimum when the flexing mechanism in flexing. The axial line of the cords should be perpendicular and passed through to the flexing axial line.
Access 220V / 50HZ power, turn on the power switch, at this time power indicator light flashes, indicate the power has accessed, to check whether the emergency stop switch has popped up, after the sample load supplied, the power cord connected, and the plug of the power cord is inserted into the load socket, adjust the voltage and current values to meet the test conditions, put up all the required weights.
Record results:
When the device is running to the number of bending times preset, the motor will automatically shut down, the indicator light will illuminate and with sound alarm when testing has been completed. The indicator light on the station remains in a state of bending test, that is the station without broken plug’s indicator light illuminate, the record value of the counter is the same with the record value preset, while the indicator light die out on the broken station, the record value of the counter must be smaller than the record value preset. Therefore, before you press the stop button, be sure to make a record of the test results
