0.96 Inch 7 Pin White Oled Display Module Compatible With SPI IIC Oled Display

0.96-Inch 7-Pin White OLED Display OLED Module Compatible With SPI IIC Oled Display

Description:

1> GND (power ground)
2> VCC (power supply is 3.3 ~ 5V)
3> DO (SPI clock line for SPI interface, IIC clock line for IC interface)
4> D1 (SPI data line for SPI interface, IIC data line for 11C interface)
5> RES (OLED reset, OLED needs to be reset after power-on-secondary reset)
6> DC (SPI data / command selection pin, used to set IIC address when IIC interface 7> CS (OLED SPI chip select, the bottom level is valid, if you do n’t want to use it, you must ground it)

Important note:

OLED displays are different from LCDs; OLEDs are spontaneously illuminated; so there is no backlight, and the screen will not react when only power is applied; there must be a correct operation of the program to display, so please pay attention to this.

FAQ:

Pls contact us to check stock quantity,price ,lead time, E-mail: info@ysonix.com

1. The maximum current is 2.5A.

          2. Up to 32 subdivisions are supported.

          3. 4-layer PCB board, better heat dissipation performance.

          4. The chip has lower internal resistance, lower heat generation and better heat dissipation.

parameter:

     Size: 1.5mmX2mm (same as 4988)

     Driven current: 2.5A

     Subdivision: 1, 1/2, 1/4, 1/8, 1/16, 1/32

     Manufacturing process: SMT placement machine manufacturing, non-manual welding, higher yield, more stable performance

Suitable for:

     Where the stepper motor needs to be driven.

     It is a necessary module for building 3d printer, cnc, engraving machine and so on.

     Supported 3D printers include Prusa Mendel, ultimaker, printbot, makerbot, etc.

     You can refer to the following Ardu code to directly drive the motor

DRV8825 features the following points:

1. Suitable for driving stepper motor below 8.2V ~ 45V 2.5A;

2. Only simple step and direction control interface;

3. Six different stepping modes: full, half, 1/4, 1/8, 1/16, 1/32;

4. The adjustable potentiometer can adjust the maximum current output to obtain a higher step rate;

5. Automatic current attenuation mode detection / selection;

6. Overheat shutdown circuit, undervoltage lockout, cross current protection;

7. Ground short circuit protection and load short circuit protection