22KW 24DWT Customized Wire Drawing Machine For Copper Wire Drawing And Annealing

HXE-24DWT Copper fine wire drawing machine with annealer

I. Application

     HXE-24DWT Copper fine wire drawing machine with annealer is used to draw and anneal single bare copper wire from 0.8mm-1.6mm to 0.1mm-0.6mm.

II. Main Technical parameters

1. Usage: Copper wire drawing and annealing

2. Inlet diameter: 0.8mm-1.6mm

3. Outlet diameter: 0.1mm-0.6mm

4. Max. mechanical speed: 2000m/min, capacity say 0.2mm, 1400m/min, 23kg per hour.

5. Dies: 24 dies

6. Slip ratio: 15%, Finished capstan slip ratio: 8%

7. Main motor: AC 3 Phase 22KW, Inverter control

8. Annealer motor: AC 3 Phase 3.7KW, Inverter control

9. Take up motor: AC 3 Phase 3.7KW, Inverter control

10. Take up capacity: 50kg for diameter 300mm iron spool (Customize)

11. Spool size: Diameter 300mm/Max (Customize)

12. Capstans: Ceramic plasma, Drawing capstan 316mm, Final capstan 268mm

13. Capstan lubrication: Water pipe spray

14. Traversing: 110W synchronous motor,transmission by timing belts.

15. Brake: 20KG-M Electromagnetic brake

16. Air pressure: 4-6kg/cm2

17. Annealing pulley: Diameter 120mm

18. Annealing volt: DC55V,

19. Annealing current: DC600A ,

20. Annealing motor power: 33KVA

21. Tension control: Annealer & Spooler Tension control by Swing arms, Air pressure auto adjust.

22. Machine dimension(L*W*H): 3500mm*1600mm*2500mm, Machine weight:3200kg

23. Power source: 415V, 50Hz(Customized)

III. Components

IV. Advantage and after-sale service

A: Advantage

(1). HENGXIE has some world famous parts suppliers, has special lubrication system for the gears and bearing.

(2). Body and other key components and parts are produced by our own factory , quality is reliable.

(3). DC. three-section annealing

(4). Our company’s developing process in more than 10 years.

B: After-self service

Our company for all machine product, since the shipment date, our company free after sale maintenance service guarantee period is:

(1) 1 year for mechanical part.

(2) 6 month for electrical part.

V. Operating procedures

5-1. Open power switch

5-2. According to the wire diameter, choose the dies (Check the die list).

5-3. Use pliers to break the wire to get a smaller section.

5-4. Use pliers to make the wire through the dies, then pull the wire out (Use foot switch to make the machine running in a low speed to make the wire move).

5-5. Wire direction, please check the Drawing for Wire path.

5-6. After make the wire through all the parts, close the annealing door and the spooling door, make the tension swing arm in the lowest position. and in running, the balance arm should be in the horizontal line. No big shake, no up and down frequently.

5-7. Open the Annealing switch, open the Pump, open and adjust the Drawing lubrication oil, Cooling water, Steam, Compressed air.

5-8. Set the length meters, then press the Start button to start the machine.