University Testing Dental Lab Furnace , 12L Box Continuous Sintering Furnace

     1800C High Temperature Dental Electric Furnace 12L Box Type University Testing

 
Dental Electric Furnace Advantage:

1. The furnace adopts all-ceramic fiber structure, light weight, small heat capacity, low loss of empty furnace, and energy saving of more than 70%.

2. The heating rate is fast and the speed can be adjusted. From room temperature to 1800 ℃, it usually takes 100-150 minutes.

3. The outer casing is made of high-quality cold-rolled steel plate, and the surface is spray-coated. The furnace door adopts a side-opening structure, which is flexible to open and close, and has a door-opening device to ensure safe use.

4. The control system adopts high-precision PID intelligent control instrument, which has the advantages of self-tuning, temperature error correction, timing, over-temperature alarm, good temperature control stability and high precision. It adopts non-contact control circuit and has the characteristics of no noise and high reliability.

Dental Electric Furnace Application:
 The dental electric furnace mainly used in chemical analysis, physical decomposition and synthesis, super hard materials (such as ceramic), Rare and precious metal smelting and purification, metal heat treatment of sintering process research and other scientific experiments. Universities and colleges, scientific research institutes, medical and health, petroleum chemical industry, mining enterprise, quality and technology supervision agencies, and other units laboratory, laboratory are the use of such equipment.
1. Gravimetric analysis;
2. Sintering;
3. Quantitative analysis;
4. Heat treating;
5. Glass preparation;

Dental Electric Furnace Introduction:

1. chamber size :from 100*100*100mm to 600*600*600mm (1L- 216L)

2. operation temperature:100C to 1700℃ .Max temperature : 1800℃

3. thermal insulation material: 1800ceramic fiber board which is made of high purity alumina fibers and alumina powder to be formed and fired in special equipment.

4. heating element :Resistance wire for 1200℃ furnace ,SiC rod for 1400℃ furnace ;MoSi2 rod heating elment for 1500-1800℃ furnace .

5. Temperature measuring instrument :K type thermocouple for 1200℃ furnace; S type thermocouple for 1400℃ furnace ; B type thermocouple for 1500-1700℃ furnace .

 
Technical Data of Dental Electric Furnace :

 
Stand model of SP laboratory heating furnace:
 

 
Our advantages:
♥ We are a manufacturer in China. So we can control the cost well.
♥ We use the top material in our furnace, imported ceramic fiber and accuracy temperature controller.
♥ We supply good service after sale, you can be assured about that
 
Our service :
♥ Reply your inquiry and questions in 24 hours.
♥ Our professional technicians answer all your questions in English.
♥ Customized design is available.