Fys35 mine flameproof and intrinsically safe remote controller, explosion-proof remote controller and explosion-proof bu

Product introduction

According to MT / t154.10-1996, this remote control receiver is named as fys-100s flameproof and intrinsically safe remote control receiver.
F Y S 100S

Main technical parameters
Working power supply: AC220 V;
Working current: ≤ 100mA;
Communication mode: wireless simplex receiving;
Antenna impedance: 50 Ω;
Receiving carrier center frequency: 433MHz;
Receiving sensitivity: ≤ - 60dbm;
Wireless remote control distance: ≥ 100m (when used with supporting equipment);
Function:
The receiver receives the radio operation signal from the remote control transmitter, demodulates the signal and outputs it in the form of relay.
When the receiver is used with fyf35 mine intrinsically safe remote control transmitter, it has the following remote control operation functions:
"East down", "West up", "south up".
Explosion proof type: explosion proof and intrinsically safe type, explosion proof mark: Exd iict4 GB ex IBD 21 t135;

Specific application areas
Crane, crane. Hydraulic crane, concrete pump truck, roller coaster, mining machinery, crown block, crane, tipper, lifting locomotive, lifting machine and other large heavy industrial machinery.

Installation steps:
The installation procedure is very simple. The required tools are as follows:
Cable wiring and material of electric drill for three purpose electric meter
(a) Please make sure that the original by wire operation of the crown block is normal.
(b) Be sure to cut off the main power supply of crown block before installation.
(c) Choose a stable and easy to see receiver location within the operating range.
(d) Please keep away from the protruding objects in the workshop, or the equipment of motor, relay, cable and high voltage wiring, and there is no barrier that may block the transmission of radio waves.
(e) Do not install a remote control with the same frequency within 50 meters.
(f) Make sure the wiring is secure and correct.
(g) After installation, the action output of the test transmitter is consistent with the original control by wire.
(h) After fixing the original control by wire, the installation is completed.

      This product has 6 single speed buttons, 1 mushroom head stop, 1 rotary switch, 8 control points, with battery voltage warning device, which can cut off the circuit automatically when the voltage is insufficient. The internal functions can be set by the computer interface. The up / down, East / West, South / North can be set to inhibit each other. The standby 1 key can be set to start, accelerate, jump, normal and other functions. The control distance of this remote controller: up to 100 meters, electromagnetic interference, safety code: more than 4.3 billion factory settings, repeated use temperature: - 35 ℃ to + 80 ℃, protection grade: IP65, transmitter power supply: DC 3V, receiver power supply: AC 380V / 220V / 36V, or DC 12V / 24V, output contact capacity: 5 amperes, fully sealed relay output. Standard configuration: 1 transmitter; One receiver; The receiver is equipped with 1m connecting cable; One operation and maintenance manual. It is suitable for single hook, single speed electric hoist or hoist crane and industrial control and remote control with less than 8 contacts.