Multifunctional Plaster Pump Machine 7.5KW Wall Cement Plaster Machine

new type cement use Plaster Pump Machine multifunctional for wall

Plaster Pump Machine

Use and Operation of Plaster Pump Machine:
1. The operator must read the operating instruction carefully; And familiar with the structure of the equipment before the operation.
2. Observe the oil mark and check whether the oil in the reducer is sufficient.
3. Check whether the connection fastening of each part of the machine is correct and reliable.
4. After the preparation work is finished, you can turn on the machine, turn on the machine to see if it is reversed, and then you can cast the mixed material inside the machine. At this time, the machine operator opens the air valve switch, and then the jet worker opens the air valve on the spray gun to pre-wet the wall surface, and then the operator begins to spray the slurry. According to the proportion of mixing water, ash, sand to adjust the air pressure, mortar distance, until the hopper and the residual material in the rotor high pressure chamber is finished, and then add water to clean the rotor high pressure chamber, can stop.

Parameters of Plaster Pump Machine:

Spraying Material of Plaster Pump Machine:
1. Cement,mortar,putty powder;
2. Paint, latex paint, powder paint;
3. Waterproof material, fireproof material;
4. Thermal insulation, sound-absorbing material,etc.

Features of Plaster Pump Machine:

1. Screw pump,high working pressure, flow stability.

2. Pump and air compressor integration, easy to move

3. High efficiency,save material,low labor intensity.

4. Spray dry powder, mortar and ordinary mortar.

5. Uniform spraying, strong adhesion.

6. Easy to operate,work reliably,long service life.

Pictures of Plaster Pump Machine: