Blasting Vibration Monitoring Equipment Ground Vibration Monitor 35cm / S

Blasting Vibration Monitoring Equipment Ground Vibration Monitor

Blasting vibration monitorng equipment collects vibration signal from blastic site without human prescense automatically. There is no sort of setting to be done. Just keep in place an switch on - data recording happens one the machine senses vibration. data will be saved when the vibration stops which can later be retrieved for further analysis and study.Blast monitoring is required in many applications related to explosions, like mining, excavations, and demolition sites.

Why Monitor Your Blasting Project?

Sensor arrangement principle:

• Before you begin,number the sensor and your monitoring-point；
• Clear the installation position's foundation surface,the sensor and your monitoring-point should be a Rigid Contact.；
• The arrow direction (horizontal radial x) of the sensor points to the explosion center, which is placed horizontally, and the installation angle error is not more than 5 °；
• Install the sensor on the sand medium, fix the sensor on a steel bar (diameter less than 10 mm) that penetrates the loose layer on the ground, and the steel bar extends out of the ground no more than a few millimeters, so it is necessary to ensure the close contact between the steel bar and the sand；
• When the sensor must be installed below the ground, in order to minimize the distortion caused by the combination with the ground, the buried depth shall be at least 3 times of the main size of the sensor.

Mode and Parameter

Mode	Parameter		Remarks
	Trigger	Length	√need setting ×without setting
Level	√	√
Wave	×	×

Product images