RF PCB – Radio Frequency Single Sided Circuit Board Rogers 4003C 0.254MM Thickness

Product Details

RF PCB introduction:

RF is Radio Frequency, referring to the radio, a high-frequency signal.

For performance index of PCB, it can be an ordinary FR4 epoxy glass fiber and also Teflon

and other dedicated microwave substrates.

RF board standards:

1, In the design of miniwatt RF PCB, main material is standard FR4 (Good insulation characteristics

uniform material, dielectric constant ε = 4,10%).

2, In the RF PCB, every component should compact configuration to ensure that the shortest connection

between the every component.

3, For a mixed-signal PCB, RF and analog section should stay away from digital part

(This distance is usually more than 2cm, at least 1cm), the digital part of the ground should be

separated from the RF part.

4, To choose the components working in high frequency environment

should use of surface-mount component as far as possible.

Because the surface-mount component is small volume generally and the pin of component

is very short.

Important Note: Below is a wide range of applications, demands, and budgets.

The table below provides general recommendations: