SMP-500 PVC grinding machine plastic pulverizer machine PE/PP
milling machine
Application
- Full-Auto SMP Series plastic pulveriser is the grinding disk type
pulverizer, it has advantages of high output, low energy cost etc.
Mainly used in pulverizing PE, PVC, PP, PS, ABS and other materials
powder processing.
- This pulverizer adopt the newly designed grinding disk, it has high
output, strong wearing resistance, the life is doubled than the
ordinary grinding disk.
- The pulverizer adopt the professional bearing to realize the high
speed and high output.
- The installation for this pulverizer is convenient, just open the
grinding room gate to clean and maintain, the whole pulverizing
process is full sealed, no powder leakage during processing.
- Full auto, full auto material feeding, full auto material output,
and full auto material sieving.
- The pulverizing gap can be adjusted easily, just use feller gauges
and adjust the screw installed on the grinding room to realize the
accurate adjust.
- The main grinder adopts the wind and water cooling type.
- The design of this machine is reasonable, the quite small
pulverizing section and the disk is almost flat and erected, the
material coming into the grinding room and can be easily pulverized
and gone out, this avoid the material stuck and temperature rise,
thus make the output of the machine more higher.
Features
- With water cycle and wind cooling, the machine can be applied into
processing heat sensitive material.
- With the tail-wagging air stream (partly eddy flow) produced by the
tail-wagging of the main shaft capstan of the machine, the input
tail-wagging materials collide strongly with the board and the
cutting blade, and was grinded into powdery (without sieving).
- Both the board and the cutting blade are made of abrasion-resistant
steel, with excellent performance after heat treatment.
- With severeness of framework, the volume of the machine is quite
small. If you open door closure, you can maintain it. It is
completely airproof and without any dust leakage.
- With winding reclaiming equipment, the machine is features by
cooling materials evenly, quick cooling and some other
characteristics.
- The new disc design is used, high-yield, strong resistance and the
life of this grinding disc is double than the ordinary.
- The use of newly designed professional bearings, and reach a high
rotation rate. At the same time using only one drive motor, to
ensure the efficient grinding crash, which greatly saves the time
and operation of machinery and control engineering.
- Installation and maintenance easy, open the door to cover clean-up.
- Milling process of the whole seal, without dust leakage.
- Full automatic feeding, the materials and sorting.
- Grinding gap adjustment is simple, just use the plug-foot bolts and
adjustments can be fine-tuning (10-120 mesh).
- The host used the water and wind double system; Rational design of
smaller cross-section of the grinding chamber, grinding is almost
flat vertical surface. Material entered the grinding chamber as
soon as caught, groud, and then rapidly removed, which eliminates
the grinding chamber of the surge in materials, heating materials
to avoid decomposition, resulting in improved production.
Technical parameters
| NO | SMP250 | SMP -400 | SMP -500 | SMP -600 | SMP -800 |
| Diameter of disc(mm) | 250 | 350 | 510 | 600 | 800 |
| Main motor power(kw) | 15 | 22-30 | 37-45 | 55 | 75 |
| Cooling method | Wind Cooling ,Water Cooling |
| Fan power (kw) | 3 | 3 | 4 | 5.5 | 7.5 |
| Vibrating sieve | ZDS600 | ZDS 800 | ZDS 800 | ZDS 1000 | ZDS1200 |
| Sieve | 30-40mesh |
| Capacity(kg/h) | 30-50 | 100-120 | 150-200 | 250-300 | 400 |
Machine pictures
