Construction Hog Wire Fence Panels , Low - Carbon Iron Wire Mesh Panel

 
Galvanized Hog Wire Fence Panels, Welded Iron Wire Mesh Panel for Construction
 
 
Description of Construction Wire Mesh
 
Steel welding network in World's application is still in its infancy, the current application of the total amount
 
of steel used in the proportion of less than one-tenth. In the early 90s of the 20th century, steel welded
 
wire mesh was only the State Science and Technology Commission, the Ministry of Construction as a key
 
to promote the project, and developed a national standard, procedures.
 
1. The steel construction to take the welding network is the world's steel industry development trend.
 
2. The reinforced mesh this new form of reinforcement, especially for large area of ​​concrete works.
 
3. China's cold-drawn ribbed steel, hot-rolled grade III steel widely, rapid application of the development
 
of welding network to provide a good material basis. Welding network product standards and the use of
 
the formal implementation of the rules for improving product quality, accelerate the promotion and
 
application has played a positive role.
 
4. The China's market demand for steel mesh great potential.
 
5. The steel mesh in the aesthetic of the favorite.
 
6. The China is the world's steel power.
 
7. The steel mesh in the domestic development has been equipped with soft and hard conditions.
 
The steel mesh in the highway cement concrete pavement project application
 
1. The concrete pavement and the fixed structure of the expansion of the joints can not be set when the
 
force bar, the adjacent structure can be placed in the end of the double-layer steel mesh; or in the length
 
of about 6 to 10 times the thickness of the range Gradually increase the thickness of 20%.
 
2. The concrete pavement and bridge phase, the bridge with a plate, should be placed in the board and
 
the concrete between the surface layer of 6 to 10mm long reinforced concrete surface transition plate.
 
When the bridge is skewed, the acute angle of the reinforced concrete slab shall be reinforced by
 
reinforcing steel mesh.
 
3.  the concrete surface layer under the box structure cross through the top surface to the bottom of the
 
surface layer of less than 400mm or embedded in the base layer, the roof of the structure and both sides
 
of the concrete surface layer should be placed double reinforced mesh , The upper and lower layers of
 
the steel mesh from the top of the surface and the bottom of a quarter of a quarter thickness.
 
When the distance between the top surface and the bottom surface of the surface layer is less than
 
1200mm, the concrete layer should be covered with a single layer of steel mesh on both sides of the
 
structure. Layer top 1/3 of 1/3 thickness.