Pacifier Clip Nipple Bite Tear Durability Test Fixture for EN1400
Product introduction:
Cut the top of the nipple from 5mm to 10mm away from the nipple and
flap joint. Insert a 5mm diameter rod into the nipple until the rod
stays at the stopper or the combination of stopper and cap. With a
speed of (10 +/- 1) mm/min, a force of 90 N +/- 5 N was applied and
maintained for 10 s +/- 0.5 s.
If the pacifier is fitted with a separate stopper and handle or
cover, all parts are tested and force is applied to the bottom of
the handle or cover. If a rod with a diameter of 5mm is not
suitable, a rod with a suitable diameter or cross-sectional area
can be selected
Technical parameters:
Product Size: φ50mm*49mm (φ*H)
Material: Stainless steel
Standard configuration: teat bite durability test fixture 1 set,
test method 1
Standards:
EN1400-2Clause 6.2.4 Figure9, GB28482-2012