|
[China]
Trade Verify
Address: A507 5F, China Zhenhua Production Center, 64Heping Road, Longhua,Shenzhen,China
Contact name:Sophie
YINGDA TECHNOLOGY LIMITED |
|
Verified Suppliers
|
|
|
288cores FTTH Closure Features
Fiber Optic Joint Box Specification
| Outside dimension (Height x Diameter) | 470mm×220mm |
| Weight (excluding outside box) | 3000 g— 3600g |
| Number of inlet/out ports | 6 pieces in general (max. 6 pieces) |
| Diameter of fiber cable | Φ8mm～Φ36mm |
| Capacity of FOSC | Bunchy: 48-288 (cores), Ribbon: up to 864 (cores) |
The splice closure is total closed with self-lock clamp, and IP68 waterproof ring, each cable port internal with metal screws and fixtures.
-------------------------------------------------------------------------------------------------------------------------------------------------------
Max. hold 6pieces splice trays, each tray hold 6fibers/layer, dual fiber 48cores, maximum 48cores in total; The back fiber holding tray is fix on bottom with screws and large management area.
--------------------------------------------------------------------------------------------------------------------------------------------------------
--------------------------------------------------------------------------------------------------------------------------------------------------------
Fiber Splicing Box Accessory list:
No. | item | Usage |
1 | Heat shrinkable protective sleeve | Protecting fiber splices |
2 | Nylon tie | Fixing fiber with protective coat |
3 | Earthing wire | Putting through between earthing devices |
4 | Abrasive cloth | Scratching fiber cables |
5 | Labeling paper | Labeling fibers |
6 | Special wrench | Installing and tightening nut of reinforced core and nut (plastic) of inlet/outlet tube |
7 | Measuring paper | To measure perimeter, of which its diameter is enlarged with seal tape |
8 | Seal tape | Enlarging diameter of fiber cable which fits in with gasket ring. |
9 | Insulation tape | Enlarging diameter of fiber cable for easy fixing |
10 | Metal hoop | For wall mounting and pole hugging |
11 | Buffer tube
| Hitched to fibers and fixed with FOST, managing buffer. |
12 | Desiccant | Put into FOSC before sealing for desiccating air |
-------------------------------------------------------------------------------------------------------------------------------------------------
Operation conditions:
Technical Specifications:
1.Seal performance: after the box is sealed, inflate to 100kPa inwards (inflation only apply to the
models with the air hole), and then soak it in the water of normal temperature, after 15 minutes
of steady observation, there is no bubble to overflow.
2. Insulation resistance: the insulation resistance between the metal work piece and the earth is
greater than 20kMΩ.
3. Pressurization: there is no breakdown or flash over under 15kVdc/1min between the metal work
piece and the earth.
4. The curvature radius of the fiber 40mm, without extra loss inside the splice tray.
5. It can bear the axial tensile strength no less than 1000N.
6. Lifetime: 25 years.
7. Other performances are all in accordance with the requirement of standard YD/T814-1998.
