Pre Terminated 1U 144 Cores MPO Cassettes Patch Panel

 Pre-terminated 144 Fiber HD Cassette Patch Panel For Fiber Optic Cables

1. Product Description:

1RU HD Fiber Optic Panels allow a mix-and-match of HD fiber and copper snap-in cassettes. Cassettes quickly snap in and pull out of the panel, making installation and changes easier than ever. Alignment tabs on the rear of the panel ensure cassettes are inserted correctly. 

With this High-Density Fiber Patch Panel, you can easily make one rack unit support your 10GB or higher applications. They allow you to quickly add new devices to your system without having to manually install or reconfigure other devices. The fiber is routed and connected on the inside of the cassette. There is no cutting, polishing, or terminating. 

2. HD Fiber Patch Panel Features & Benefits:

1. Available with OM4 or single-mode fiber arrays and adapters

2. Also available with standard or low loss (Elite) ferrule MTP connectors

3. Connect together with high-density female MTP* cable assemblies as an interconnection network

4. Significantly reduce installation time and labor by eliminating field connector terminations

5. Constructed of lightweight yet durable rolled steel our loaded cassette weighs less than 5 pounds

6. Pre-terminated High Density 144 Fiber HD Cassette

7. Mounts on standard 19" racks or cabinets

3. HD  Patch Panel Application:

1. Storage area networking fiber channel

2. High density architectures

3. Data communication network

4. Optical System Access network

4. Specification and Technology Parameters :

5. Frequent Q&A For HD Fiber Patch Panel:

Q: What are the benefits of using a patch panel?
A: Patch panels will allow testing routing and maintenance of network cables connected to your network. With a patch panel this is quickly done just by making changes to cables on the patch panel itself. Patch panels also allow for easier cable management and identification of cable routing.

Q: What is a rack unit?
A: A rack unit U or RU is a unit of measure that describes the height of equipment designed to mount in a rack. A rack unit is 1.75 inches. Typically one rack unit will take three vertical screw holes on each side of a standard rack.

Q: Can I use any fiber patch cable in my network with my enclosure?

A: If your fiber enclosure is loaded you must have cables that are compatible with the included adapters. For unloaded enclosures, you must select adapter panels that correspond to your fiber connector type or use a splice tray for single- and mass-fusing.

Q: What are the differences between the fiber connectors?

ST- Uses a push and turn to lock system

SC- Has a molded plug casing with push and pull locking system

6. More HD Fiber Optic Patch Panel Options:

7. Wuhan Geehe Comm Service: