Guangzhou Jiqian Fiber Optic Cable Co., Ltd. |
Verified Suppliers
|
|
Characteristics
1. Can be installed without shutting off the power;
2. Excellent AT performance, The maximum inductive at the operating
point of AT sheath can reach 25kV;
3.Light weight and small diameter reducing the load caused by ice
and wind and the load on towers and backprops;
4. Large span lengths and the largest span is over 1000m;
5. Good performance of tensile strength and temperature;
6.The design life span is 30 years.
Fiber parameter
Item | Unit | Specification | |
Fiber Type | G.652D | ||
Mode field diameter | 1310nm | mm | 9.2±0.4 |
1550nm | mm | 10.4±0.8 | |
Cladding diameter | mm | 125.0±1 | |
Cladding non-circularity | % | ≤1.0 | |
Core/cladding concentricity error | mm | ≤0.5 | |
Coating diameter | mm | 245±5 | |
Coating non-Circularity | % | ≤6.0 | |
Coating/cladding concentricity error | mm | ≤12.0 | |
Cable cut-off wavelength | nm | ≤1260 | |
Attenuation Coefficient | 1310nm | dB/km | ≤0.36 |
1550nm | dB/km | ≤0.22 | |
Proof stress level | kpsi | ≥100 |
Mechanical and Environmental Characteristics
Performance parameters | Rated tensile strength (RTS) |
KN |
4.5 |
Allows the use of tension (MAT) |
KN | 2 | |
The average annual running tension (EDS) |
KN |
1.8 | |
Limit running tension (UES) |
KN |
3.2 | |
Thermal expansion coefficient |
10-6/℃ |
1/℃ | |
Young's modulus |
kN/mm2 |
3.75 | |
The compressive strength | For a long time | 1000N/100mm | |
In the short term | 2000N/100mm | ||
The minimum bending radius | run | 115mm | |
laying | 235mm | ||
laying | -20~+60°C |
Applicable temperature range | Transportation and operation | -40~+60°C | |
Yu long fiber optic cable |
0.4-0.6% | ||
life time | Max 25 year |
Features:
Low attenuation and dispersion, special control of exceed length
ensure the good transmission performance in varying environment.
Excellent mechanical performance
Good flexibility and bending performance
Small outer diameter, lightness and compact construction
Product description
ADSS cable is loose tube stranded. Fibers, 250μm , are positioned into a loose tube made of high modulus plastics.The tubes are filled with a water-resistant filling compound. The tubes (and fillers) are stranded around a FRP(Fiber Reinforced Plastic) as a non-metallic central strength member into a compact and circular cable core.After the cable core is filled with filling compound. it is covered with thin PE (polyethylene) inner sheath.After stranded layer of aramid yarns are applied over the inner sheath as strength member,the cable is completed with PE or AT (anti-tracking) outer sheath.