|
[China]
Trade Verify
Address: Room 101, 1st Floor, No. 6, Third Street, Pingshan Industrial Zone, Shibi Street, Panyu District, Guangzhou, China
Contact name:Zoe Zou
Sinuo Testing Equipment Co. , Limited |
|
Verified Suppliers
|
|
|
IEC 62196 Anti-Shock Probe Experiment For Electric Vehicle Connector Test
Complied Standards & Clauses
IEC 62196-1Ed.4CDV 2020 clause 10.1, 26.6.
Equipment Overview
This equipment meets the requirements of IEC 62196-1Ed.4CDV 2020 clause 10.1, 26.6.
It is used with the testing probe for the convenience and correctness. In the two output electrodes, the low potential (the red one) is connected with the energized part of the electrical appliance and the high potential is connected with the input terminal of the probe used. At this time, conduct the circuit and push the button of start. Then use the probe to touch the parts that maybe electrified. If the alarm of the equipment sounds, it is proved that the testing part is electrified. Then push the button of reset and cut down the circuit.
Technical Parameters
| Applied Standards | IEC 62196-1Ed.4CDV 2020 |
| Applied Clauses | Clause 10.1, 26.6. |
| Working Voltage | AC 220V±5%, 50HZ±1% |
| Output Voltage | AC40-50V |
| Relative Humidity | ≤80% |
| Temperature Range | 0-40℃ |
| Use Requirements | No shaking and no corrosive gas |
