Home Companies Shenzhen Anpo Intelligence Technology Co., Ltd.

1920x1080 OLED Head Mounted Display 41 Degree Binocular MIPI HUD

Contact Us

[China]

Trade Verify

Address: 11th Floor, Building B, Silver Star Technology Building, No.1301 Guanguang Road, Guanlan Street, Longhua New District, Shenzhen, China

Contact name:Layla

Shenzhen Anpo Intelligence Technology Co., Ltd.

Verified Suppliers

Trust
Seal
Verified
Supplier
Credit
Check
Capability
Assessment

1920x1080 OLED Head Mounted Display 41 Degree Binocular MIPI HUD

Country/Region	china
City & Province	shenzhen guangdong

Product Details

Micro Display Module 1920*1080 Resolution OLED 41 Degree For Head Up Display

This display is a 0.49 inch diagonal, 1920(RGB) × 1080 dots active matrix color OLED module based on single-crystal

silicon transistors.

This module integrates panel driver and logic driver, and realizes small size, light weight, low power consumption and high resolution.

Product Details

Resolution	Full-HD 1920*1080
Display Material	OLED
Screen Size	0.49"
Quantity	2 screens, binocular
FOV	41°
Brightness	1800 nits
Contrast Ratio	50000:1
Frame Rate	60Hz~90Hz
Interface	MIPI

Features

High resolution
Large FOV
High brightness
Plug and play
Light and small
Ultra high contrast
Wide color gamnt
Fast response speed

Interface

I2C Interface

The I2C-bus is for bi-directional, two-line communication between different ICs or modules.The two lines are the Serial Data Line (I2C_SDA) and Serial Clock Line (I2C_SCL). Both lines mustbe connected to a positive power supply via pull-up resistors. Data transfer can be initiated only whenthe bus is not busy. The acknowledge takes place after every byte. The acknowledge bit allowsthe receiver to signal the transmitter that the byte was successfully received and another byte maybe sent. The master generates all clock pulses, including the ninth acknowledge clockpulse.

I2C-Bus Protocol

Before any data is transmitted on the I2C-bus, the device which should response is addressed first. There are several slave addresses can be selected by MCU. The slave addressing is always carried out with the first byte transmitted after the START procedure.